ALLNIC AUDIO D-3000 Benutzerhandbuch - Seite 8
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Medienkonverter ALLNIC AUDIO D-3000 herunter. ALLNIC AUDIO D-3000 11 Seiten. Digital to analog converter
Seite druckenWhen you are finished listening, turn off your power amplifier(s); then turn off your preamplifier and
then turn off your sources last, including the D-3000 by pressing in the bottom of the on/off rocker
switch, located on the left side panel near the front of the unit.
NOTE: While the D-3000 DAC is run in and tested at the factory, users have reported that the sound
improves steadily through the first two to three hundred hours of use.
In the case of any failure, please contact your Allnic dealer for assistance.
THE REMOTE CONTROL
The remote control allows remote operation of all the functions on the front panel of the D-3000. It
does not support the on/off function. The remote control provided is a standard Apple product. All
functions controllable by the remote are manipulated by using the large button at the top of the
remote control, which is surrounded by a black ring with a white dot at its top and bottom and left
and right sides.
The DAC functions are selected as follows:
Pressing the upper part of the black main button ring selects the various inputs from right to
•
left on the face of the unit
Pressing the lower part of the black main button ring selects the various inputs from left to
•
right on the face of the unit
Pressing the right side of the black main button ring toggles CONV, conversion to DSD, on and
•
off, i.e., between conversion to DSD and a source's incoming sample rate, or one of the up-
sampling rates (the latter only if you were previously in up-sampling)
Pressing the silver central "enter" button toggles UPSAMPLE on and off and when on, cycles
•
through the various up-sampling rates
The remote control's "left" side of the black main button ring, the "Menu" and the "Play/Pause"
buttons have no functions for the D-3000 DAC.
If you are using an Apple device as a source or controller, or have any other Apple device nearby, it
may also respond to the D-3000 remote control. If you need to use an Apple device at the same time
as you are using the D-3000 and cannot move your Apple device out of range of the D-3000 remote
control, you should be able to disable the remote control sensor of the Apple device in the device's
System Preferences. Instructions for doing this are available on-line.
THE CURRENT METER
The illuminated meter on the D-3000's front panel indicates the current supply to the tubes in the D-
3000. The meter will indicate failure or damage to the function of the unit. The needle should be
between the two almost vertical lines just to the right of centre on the meter face. Any failure of the
tubes or circuits in one or the other of the D-3000's channels is indicated by the needle on the meter
moving out from between the two lines. If the needle moves to the right of the two lines, a type of