Diamond TQ-400 Installations- und Betriebshandbuch - Seite 12
Blättern Sie online oder laden Sie pdf Installations- und Betriebshandbuch für Kommerzielle Lebensmittelausrüstung Diamond TQ-400 herunter. Diamond TQ-400 20 Seiten. Electric conveyor toasters
Seite druckenSET-UP
CAUTION
Unit is not weatherproof. For safe and proper
operation the unit must be located indoors
where the ambient air temperature is a minimum
of 70°F (21°C) and a maximum of 85°F (29°C).
CAUTION
The toasting of coated or buttered products
such as garlic bread, cheese sandwiches and
sweet rolls is NOT recommended. Residue will
reduce toaster performance and could possibly
ignite inside the toaster.
CAUTION
When setting up the unit for operation, make
sure power to the unit is off and the toaster is at
room temperature. Failure to do so could result
in personal injury.
TOAST FEED RAMP
The toast feed ramp is installed at the factory and
can be used in two positions. See Figure 6.
1. When in the upright position, the toaster is set for
automatic feed. Bread products enter the toaster
by placing them on the feed ramp and releasing.
2. For manual feeding of product, tip the feed ramp
until it rests on top of the unit. In this position
bread products can be manually loaded by
placing directly on the conveyor belt.
CAUTION
Some exterior surfaces on the unit will get hot.
Use caution when touching these areas to avoid
injury.
TOAST CRUMB TRAY
Install toast crumb tray directly below the conveyor
belt and below the stop pins. Insert until the front of
the crumb tray meets the stop pins. See Figure 7.
CAUTION
To avoid damage to the unit or injury to
personnel always operate toaster with crumb
tray installed.
CAUTION
To avoid any injury, do not remove the crumb
tray for cleaning until toaster is cool.
Figure 6. Toast Feed Ramp
Stop Pins
Toast Crumb
Tray
Figure 7. Toast Crumb Tray
9
INSTALLATION
Form No. TQ2M-1005