Aquatic AQ-SWA8-6BT Benutzer- und Installationshandbuch - Seite 5
Blättern Sie online oder laden Sie pdf Benutzer- und Installationshandbuch für Verstärken Aquatic AQ-SWA8-6BT herunter. Aquatic AQ-SWA8-6BT 11 Seiten. Combined bluetooth stereo subwoofer with bluetooth & full range speaker outputs
Auch für Aquatic AQ-SWA8-6BT: Benutzer- und Installationshandbuch (11 seiten), Benutzerhandbuch (2 seiten)
Seite drucken
Installation & Wiring
3.1 Connecting the Combined Stereo Subwoofer
The AQ-SWA8-6BT requires a wiring harness in order to connect to power and speakers.
All open wire connections should be soldered and protected against water and dust for best long
term performance.
1. You will need an Aquatic AV AQ-UNH-2 wiring harness or the factory harness on your stereo
system to complete the install.
2. Follow the Wiring Harness diagram below. Use a minimum of 18 gauge wire for power and
ground.
3. When the unit is powered on you will see the LED light up green on the control panel.
Variable Voltage Input Selector
3.2 Wiring Harness
Left Front Speaker
4 Ohm
Left Rear Speaker
Left Rear Speaker
4 Ohm
Right Front Speaker
4 Ohm
Right Rear Speaker
Right Rear Speaker
4 Ohm
www.aquaticav.com
Halo Aerial Technology
Connector
(White/strip)
(
(White/strip)
i /
i )
OPTIONAL
OPTIONAL
Combined Bluetooth Stereo Subwoofer AQ-SWA8-6BT
Green Power LED
Fuse Box
Power Antenna (7)
No lower than a 4 Ohm speaker should be
No lower than a 2 Ohm load should be used
used or damage may occur to the Combined
or damage may occur to the Digital Media
Stereo Subwoofer.
Locker.
Make sure the polarity of speakers are
Make sure the polarity of speakers are
connected correctly.
connected correctly.
RCA Input (Red & White)
Remote Control (optional)
Connection
Wiring Harness
connections (see below)
d
5