Aquatic AQ-DM-5BT DIGITAL MEDIA LOCKER Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Schiffsausrüstung Aquatic AQ-DM-5BT DIGITAL MEDIA LOCKER herunter. Aquatic AQ-DM-5BT DIGITAL MEDIA LOCKER 12 Seiten. For bluetooth & mp3 devices

Seite drucken
Getting Started

1.3 12-pin Harness Connection

The AQ-DM-5BT includes the universal harness AQ-UNH-2 in order to connect the dock to power
and speakers.
All open wire connections should be soldered and protected against water and dust for best long
term performance.

1.4 Mounting the Digital Media Locker

1. A mounting template is included. Aquatic
AV recommends using the 'measure twice, cut
once' method!
2. Once the mounting hole is complete, make
sure the outside surface is clean and clear of
debris. The Digital Media Locker has an exter-
nal water/dust proof gasket, but this requires
a clean and flat surface for best performance.
3. The Digital Media Locker has six (6) front
screws. Drive the screws using a screw driver.
During final mounting apply equal pressure to
all points for the best water/dust outer seal per-
formance. Make sure screws are snug and do
not over tighten.
4. Review all outside surfaces of the Digital
Media Locker to ensure proper water/dust seal.
This is important for long term environmental
protection performance for your digital media
device.
www.aquaticav.com
(White/strip)
Fuse Box
Power Antenna (7)
No lower than a 2 Ohm load should be used
No lower than a 2 Ohm load should be used
or damage may occur to the Digital Media
or damage may occur to the Digital Media
Locker.
Locker.
Make sure the polarity of speakers are
Make sure the polarity of speakers are
connected correctly.
connected correctly.
Digital Media Locker AQ-DM-5BT
194mm
66.8mm
118mm
95mm
4