Alpha Professional Tools CCP005 Technische Hinweise

Blättern Sie online oder laden Sie pdf Technische Hinweise für Werkzeuge Alpha Professional Tools CCP005 herunter. Alpha Professional Tools CCP005 2 Seiten.

Seite drucken

Contour for Porcelain

The Alpha® Contour Blade, introduced several years ago for cutting curves in

granite and other hard natural and engineered stones, is the blade of choice for hand

curve cutting operations such as, performing sinkhole cut-outs. Now, with the

introduction to the marketplace of 3cm porcelain slab, Alpha® has developed the

Contour Blade for Porcelain.Due to the nature of porcelain, traditional diamond stone

blades are not suitable for working on this material. Porcelain is a hard, dense,

homogenous material that is prone to chipping, which can lead to fractures. Alpha®

has designed a complete Porcelain Slab Fabrication System. The Alpha® Contour

Blade for Porcelain is a key component to that system intended for working on

porcelain without chipping or damaging the material.For the best performance, use

the Alpha® Contour Blade for Porcelain on the new AWS-125 Wet Stone Cutter. The

combination of the Alpha® Contour and the AWS-125 helps to assure the success of

performing sink cut-outs without breaking the rim.While the Alpha® Contour Blade

may be used wet or dry; due to the nature of porcelain, Alpha® Contour Blade for

Porcelain must be used wet.

Part No.

Size

CCP005

How to Use

Attach the Alpha® Contour for Porcelain blade onto your Alpha® AWS-125 Wet Stone Cutter. Use the third flange

provided with the Alpha® AWS-125 Wet Stone Cutter when mounting the Alpha® Contour for Porcelain onto this stone

cutter to insure adequate clearance. (The Alpha® Contour for Porcelain blade can also be mounted onto high-speed

angle grinders; however; these grinders must be equipped with a water supply since this Contour for Porcelain blade is

a WET USE ONLY blade).

Alpha® recommends the step-cutting process; a total of three passes should be used to cut 3cm (1-1/4") thickness

material. On the first pass you need to score the material 1/8" from the drawn template hole making sure you are

scoring inside the template hole. On the second pass you should cut half-way through the material, and, on the third

pass the blade should be cutting completely through the material.

Due to the manual operation, we recommend cutting 1/8" inside of mark of sink template to ensure good results.

Always refer to the operation manual of the power tool for correct mounting procedures.

Frequently Asked Questions (FAQs)

The Alpha® Contour for Porcelain is available in what sizes?

This blade is available in a 5" diameter only.

What is the arbor size if this blade?

The arbor size is 7/8".

What is the maximum RPM this blade should be used at?

The maximum RPM for this blade is 12,200. This blade should not be used at RPM lower than 9,000.

What is the purpose of the side protection segments on both sides of the blade?

These segments assist the blades cutting ability to cut curved areas cleanly as well as grind away material to make a

wider kerf, allowing the blade to make tighter radiuses. They also prevent undercutting.

Document # 6320 - Rev.-September 2007

Technical Notes

Maximum RPM

12,200

www.alpha-tools.com

Arbor

7/8"

Sections:

- How to Use

- Frequently Asked

Questions (FAQs)

- Helpful Hints

- Reference

Page 1 of 2