ARCCAPTAIN CUT50 Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Schweißen System ARCCAPTAIN CUT50 herunter. ARCCAPTAIN CUT50 20 Seiten. Plasma cutter 50a

1. SAFETY

1) Make sure the place to install the machine can bear the weight of the cutting machine.

2) Do not install the machine at places where water droplet splash may be produced,

such as near water pipes.

3) Cutting should be carried out in dry environment with humidity of 90% or less.

4) The temperature of the working environment should be between -10℃ and 40℃.

5) Avoid cutting in the open air unless sheltered from sunlight and rain. Keep it dry at all

times and do not place it on wet ground or in puddles.

6) Avoid cutting in dusty area or environment with corrosive chemical gas.

7) Do not carry out cutting with the cutting machine placed on a platform with a pitch

greater than 10°.

Over current/over voltage/over heating protection circuit is installed in this machine. When

the mains voltage, output current or inner temperature exceeds the set standard, the

machine will stop automatically. However, excessive use (e.g. too high voltage) of

machine may also damage the machine, so please note:

Digital Welder Expert, Know You More

Beware of electric shock!

Install grounding



standard.

Do not touch live parts with naked skin, wet gloves or



wet clothes.

Be sure you are insulated from ground and workpiece.



Cover the cover plate of the machine before power on to



avoid an electric shock.

Confirm the safety of your working position.



Beware of fire hazard!

Please install the machine on non-combustible materials



to avoid a fire.

Make ensure there are no inflammables near the cutting



position to avoid a fire.

Beware of explosion!

Do not install the machine in an environment with



explosive gas to avoid an explosion.

device

according

to application

https://www.arccaptain.com