Epson ActionTower 3000 Computer Dieses Handbuch zuerst lesen - Seite 15

Blättern Sie online oder laden Sie pdf Dieses Handbuch zuerst lesen für Drucker Epson ActionTower 3000 Computer herunter. Epson ActionTower 3000 Computer 29 Seiten. Product information guide
Auch für Epson ActionTower 3000 Computer: Benutzerhandbuch (34 seiten), Benutzerhandbuch (38 seiten), Austausch von Patronen (2 seiten), Produktinformation Handbuch (11 seiten), Handbuch zur Schnelleinrichtung (4 seiten)

Note

You can install C-type batteries in your speakers or obtain a

DC 6-Volt input jack to power the speakers independently

and use them as amplified speakers. This will boost the

speaker's bass response and allow you to adjust the volume

using the speaker's controls. If you do this, be sure to set the

Amp switch on the back of each speaker to the On position

and turn on the speakers before you turn on your system. Be

sure to connect the speakers to the OUT connector on the

sound card, as described below.

Before you connect your speakers, locate the battery

compartment on the back of each one. Inside the compartments

are the cables you use to connect the speakers to the computer.

Remove the cables. If necessary, attach one of the cable's wide

connectors to the socket on the back of each speaker.

If you are using your speakers as unamplified speakers, you

must do the following before you connect them to your system:

Turn off your computer

If there is a power button on the front of each speaker, set it

to the Off position

If there is an Amp switch on the back of each speaker, set it

to the Off position to turn off the speaker's amplifier.

Caution

Do not connect mono speakers to the OUT connector; you

could damage the speakers' amplifiers.

Read This First