Cisco 2970 - Catalyst Switch Handbuch - Seite 14

Blättern Sie online oder laden Sie pdf Handbuch für Schalter Cisco 2970 - Catalyst Switch herunter. Cisco 2970 - Catalyst Switch 19 Seiten. Ios software release 12.1(14)ea1
Auch für Cisco 2970 - Catalyst Switch: Produkt-Bulletin (5 seiten), Produkt-Support-Bulletin (6 seiten), Produkt-Support-Bulletin (6 seiten)

Seite drucken

Cisco - Connecting a Terminal to the Console Port on Catalyst Switches

Use a null-modem cable to connect the switch to a remote DCE device, such as a modem or a Data

Service Unit (DSU). Use a straight-through cable to connect the switch to a data terminal equipment

(DTE) device, such as a terminal or a PC.

The console port of the Catalyst 4000 Supervisor Engine I uses a DB-25 connector and supports Data

Terminal Ready (DTR), Data Set Ready (DSR), Clear To Send (CTS), and Request To Send (RTS)

handshake signals.

Table G-1

Table G-1: Catalyst 4003 Console Port Pinouts

Signal

Ground

RxD

TxD

CTS

RTS

Ground

DTR

DSR

Connecting a Terminal to the Catalyst 4000/4500

Supervisor Engine II/II+/III/IV, 2948G, 2980G, and

4912G

You may configure the Catalyst 4000/4500 series switches from a direct console connection to the

console port.

Use the RJ-45-to-RJ-45 rollover cable and RJ-45-to-DB-9 female data terminal equipment (DTE)

adapter (labeled "Terminal") to connect the console port to a PC running terminal emulation

software. If you are using a direct console connection, configure your terminal emulation program

for 9600 baud, 8 data bits, no parity, and 1 stop bit.

Table H-1

lists the switch console port pinouts. Use a straight-through cable to connect the switch to a

DTE device, such as a terminal or a PC.

Table H-1: Catalyst 4000/4500 Supervisor II and higher, 2948G, 2980G, and 4912G Console Port

http://www.cisco.com/warp/public/473/9.html (14 of 19) [9/4/2003 12:36:03 PM]

lists the Catalyst 4000 Supervisor Engine I console port pinouts.

Direction

Input

Receive Data

Output

Transmit Data

Input

Clear To Send

Output

Request To Send

Output

Data Terminal

Input

Data Set Ready

Description