Resolved Caveats
CSCso57496
•
A switch no longer fails when you enter the configure replace privileged EXEC command, and a
banner is already present in the switch configuration.
CSCso90107
•
You can now query the bgpPeerTable MIB for VPN/VRF interfaces.
CSCsq51052
•
The output of the show ip ssh privileged EXEC command no longer displays SSH Enabled -
version 2.99. Instead, a correct SSH version (1.5, 1.99 or 2.0) now appears.
CSCsx49718
•
Re-authentication now occurs on a port under these conditions:
–
–
–
CSCsy66686
•
The switch no longer reloads when the default port cost of service (CoS) value is updated on a port
that has a policy map configured and CoS override enabled with the mls qos cos override privileged
EXEC command.
CSCsy72669
•
If a link failure occurs on a secondary edge port, preemption now occurs after the link comes up.
CSCsz12381
•
When open1x authentication and MAC authentication bypass are enabled on a port, an IP phone is
connected to the port, and DHCP snooping is enabled on the switch, DHCP traffic is now forwarded
on the voice VLAN before open 1x authentication times out and the switch uses MAC authentication
bypass to authorize the port.
•
CSCsz13490
The switch no longer reloads when you enter several key strokes while in interface-range
configuration mode.
•
CSCsz14369
If MAC authentication bypass is enabled and the RADIUS server is not available, the switch now
tries to re-authenticate a port after a server becomes available.
CSCsz77920
•
If you are configuring Flexible Authentication Ordering with web authentication on a switch port
and the switch uses 802.1x to authenticate the host, Address Resolution Protocol (ARP) now works
properly.
CSCsz79652
•
A memory leak no longer occurs when Cisco Network Assistant is polling the switch and the ip http
server or ip http-secure-server global configuration command is enabled.
CSCta32597
•
A switch no longer fails when a host moves from a dynamically assigned VLAN to a configured
VLAN.
Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(50)SE and Later
14
The port is in single-host mode.
The port is configured with the authentication event no-response action authorize vlan
vlan-number command.
An EAPOL start packet is sent to the port.
OL-18274-02
Seite drucken