Accutone TB610 Benutzerhandbuch - Seite 2
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Kopfhörer Accutone TB610 herunter. Accutone TB610 3 Seiten. Telephone headset
Seite drucken1.c) Wearing your telephone headset
To accommodate left or right ear wearing you can rotate the mic boom as shown in
image A.
The headband can also be adjusted to position the stabiliser earpad in the correct and
most comfortable position for you.
1.d) Using the flexible mic boom
Accutone's telephone headsets have rotatable and flexible mic booms which allow you
to easily adjust the boom so the mic capsule is correctly positioned, see image right ©
2.) USING THE QUICK DISCONNECTOR
Each Acctuone telephone headset comes with a quick disconnector linking your
headset portion to the modular plug cable (bottom cord). This is for your convenience,
so you don't have to remove your headset when you want to leave your desk for a
short while. Connect the cables as illustrated, until you hear a slight clicking sound.
3.) INSTALLING YOUR HEADSET
There are two ways of connecting your Accutone headset to your telephone.
3.a) Direct connection
If you have a telephone with a dedicated headset port, simply plug the headset directly
into the headset port on your telephone. You do not need to use the configuration box.
Features such as mute and volume control will be controlled by your telephone.
Please refer to the instruction manual for your telephone if you are unsure how to do
this.
Please note your telephone handset must be fitted with a standard RJ11 plug (this is
the type of plug used for most headset connections on corded telephones).
3.) Connection using the C100 configuration box provided
If you have purchased the C100 configuration box this will give you the additional
benefits of switching between your headset and telephone handset as well as a mute
facility.
3.a) Identifying key parts of your C100 configuration switch
1,2,3,4 - Configuration switch part1
A,B,C - Configuration switch part 2
3.b) How to install and configure the C100 configuration switch
1.
Disconnect the handset cord from your telephone
2.
Connect the cable from the configuration box into the handset socket of your
telephone
3.
Connect the handset cord into the socket on the configuration box
Connect your headset to the socket on configuration box (4)
4.) USING YOUR HEADSET
4.a) Making calls
To make a call you will need to raise the telephone handset, this will place the
telephone "off hook" and you should hear the dial tone through the headset, just dial
the number you require.
When the call is finished replace the telephone handset to place the telephone "on
hook".
4.b) Receiving calls
To receive a call when the telephone rings, put on your headset (if you are not already
wearing it) and raise the telephone handset to accept the call and place the telephone
"off hook".
When the call is finished replace the telephone handset to place the telephone "on
hook".
Congratulations, you are now connected!
5.) USING THE ACCUTONE TM363 CONVERTIBLE HEADSET
To convert your TM363 from over-the-head use to over-the-ear hold the two area
s indicated and pull the headband (1) away from the ear piece (2) in a vertical
direction (To re-insert the headband simple insert the bottom part into the rubber
ring at the top of the ear piece.)Now insert the plastic rod at the end of the
ear loop (3) into the rubber ring at the top of the earpiece as shown. With little
pressure, it should fit easily; stop when you feel resistance.
Please Follow the Instructions in This Manual to Ensure Successful Operation of Your Headset.
Helpline 0871 200 2276
Configuration Switches
Handset/headset selection & Mute
Page 2