Siemens EH8 FF Series Gebrauchsanweisung - Seite 18

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Kochfeld Siemens EH8 FF Series herunter. Siemens EH8 FF Series 28 Seiten.
Auch für Siemens EH8 FF Series: Informationen zur Verwendung (20 seiten)

Energy consumption indicator

en
[Energy consumption
indicator
T his function indicates the total amount of energy
E n e r g y c o n s u m p t i o n i n d i c a t o r
consumed by this hob the last time it was used for
cooking.
Once the hob is switched off, the energy consumption
is displayed in kilowatt hours (e.g.
seconds.
The accuracy of the information displayed depends on
the voltage quality of the mains power supply, among
other factors.
You can find out how to switch this function on in the
section on ~ "Basic settings"
18
.
kWh) for 10
‹‰
tCookware check
T his function can be used to check the speed and
C o o k w a r e c h e c k
quality of the cooking process depending on the
cookware.
The result is a reference value and depends on the
properties of the cookware and the hotplate being used.
With the cookware still cold, fill it with approx.
1.
200 ml of water and place it on the centre of the
hotplate with the diameter that most closely matches
that of the base of the cookware.
Go to the basic settings and select the
2.
Touch the settings range.
3.
display.
The function has now been activated.
After 10 seconds, the result for the quality and speed of
the cooking process will appear on the hotplate display.
Check the result using the following table:
Result
The cookware is not suitable for the hotplate and will therefore
not heat up.*
The cookware is taking longer to heat up than expected and the
cooking process is not going as well as it should.*
The cookware is heating up correctly and the cooking process
ƒ
is going well.
* If there is a smaller hotplate available, test the cookware again on the
smaller hotplate.
To reactivate this function, touch the settings range.
Notes
If the diameter of the hotplate used is much smaller
than the diameter of the cookware, only the middle
of the cookware can be expected to heat up. This
may result in the cooking results not being as good
as expected or being less than satisfactory.
You can find information on this function in the
section on ~ "Basic settings".
You can find information on the type, size and
positioning of the cookware in the section on
~ "Induction cooking".
setting.
™‚ƒ
will flash on the hotplate
A