Ricoh Pro C7100sx Dieses Handbuch zuerst lesen - Seite 34

Blättern Sie online oder laden Sie pdf Dieses Handbuch zuerst lesen für Drucker Ricoh Pro C7100sx herunter. Ricoh Pro C7100sx 40 Seiten.
Auch für Ricoh Pro C7100sx: Starter-Handbuch (40 seiten)

Ricoh Pro C7100sx Dieses Handbuch zuerst lesen
3. Other Information for This Machine
and laser beams are generated in Continuous Wave (CW) mode. The VCSEL has forty light sources and
the maximum output power of each light source is 1.23 milliwatt.
Caution
Use of controls or adjustments or performance of procedures other than those specified in this manual
might result in hazardous radiation exposure.
Laser Safety for Media Identification Unit Type S3
CDRH Regulations
Media Identification Unit (optional) complies with 21 CFR 1040.10 and 1040.11 except for deviations
pursuant to Laser Notice No.50, dated June 24, 2007. Media Identification Unit contains one VCSEL
(Vertical Cavity Surface Emitting Laser), 772–792 nanometer wavelength. The beam divergence angle
is 5.3 degrees (minimum) and 7.9 degrees (maximum) in the vertical direction, and 5.3 degrees
(minimum) and 7.9 degrees (maximum) in the horizontal direction, and laser beams are generated in
Continuous Wave (CW) mode. The VCSEL has twelve light sources and the maximum total output power
is 2.5 milliwatt.
Caution
Use of controls or adjustments or performance of procedures other than those specified in this manual
might result in hazardous radiation exposure.

Notes to USA Users of FCC Requirements

Part 15 of the FCC Rules
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
Note:
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
32