Cisco 12000 - Series Chassis Modular Expansion Base Anleitung zum Ersetzen Handbuch - Seite 26
Blättern Sie online oder laden Sie pdf Anleitung zum Ersetzen Handbuch für Netzwerk-Router Cisco 12000 - Series Chassis Modular Expansion Base herunter. Cisco 12000 - Series Chassis Modular Expansion Base 40 Seiten. Internet router line card failures
Auch für Cisco 12000 - Series Chassis Modular Expansion Base: Datenblatt (9 seiten), Übersicht Handbuch (6 seiten), Handbuch zur Hardware-Fehlerbehebung (18 seiten)
Seite drucken
Removing and Installing Line Card Memory
Remove the new DIMM from its protective antistatic bag.
Step 3
Grasp the edges of the DIMM only. (See
Step 4
DIMM, the metal traces, or fingers, along the edge of the DIMM, or the pins in the DIMM socket.
To position the DIMM for insertion, orient it at the same angle as the DIMM socket. The two notches
Step 5
(keys) on the bottom edge of the module ensure that the DIMM edge connector is registered properly in
the socket.
If necessary, rock the DIMM back and forth gently to align it in the socket.
When inserting DIMMs into a socket, apply firm, but not excessive, pressure. If you damage a DIMM
Caution
socket, you must return the line card for repair.
Gently insert the DIMM into the socket and push until the DIMM snaps into place and the release lever
Step 6
is flush against the side of the socket. (See
Verify that the release lever is flush against the side of the socket. If it is not, the DIMM might not be
Step 7
seated properly. On a socket with dual release levers, both levers should be flush against the sides of the
DIMM.
If the module appears misaligned, carefully remove it and reseat it, ensuring that the release lever is flush
against the side of the DIMM socket.
Repeat
Step 8
Removing a SODIMM
ISE, Engine 4, and Engine 4+ line cards use a different type of route memory than Engine 0, 1, and 2
line cards. A 144-pin small outline DIMM (SODIMM) is used for route memory. To remove a SODIMM
from a line card, follow these steps:
Step 1
Attach an ESD-preventive wrist strap and follow its instructions for use.
Place the line card on an antistatic mat so that the faceplate is nearest to you.
Step 2
Locate the route memory socket on the line card. (See
Step 3
4 and Engine 4+ line cards.)
Remove the SODIMM memory-retaining clip from the memory module socket. Grasp the latch arm
Step 4
intersection located on each side of the clip and gently slide the clip out. (See
retaining clip.
If the retaining clip is bent or damaged, do not attempt to fix or reuse it. This can cause serious damage
Caution
to the line card. Each SODIMM replacement ships with a spare retaining clip, in case there is any
damage to the existing clip.
Cisco 12000 Series Router Memory Replacement Instructions
26
Step 3
through
Step 7
to install any remaining DIMMs for your memory configuration.
Figure
8.) Do not touch the integrated circuit devices on the
Figure
9.)
Figure 5
for ISE line cards or
Figure 6
for Engine
Figure
11.) Save the
78-4338-16