Cisco 4700M Upgrade-Handbuch - Seite 17

Blättern Sie online oder laden Sie pdf Upgrade-Handbuch für Netzwerk-Router Cisco 4700M herunter. Cisco 4700M 24 Seiten. Upgrading memory
Auch für Cisco 4700M: Installationshandbuch (18 seiten), Ersatz-Handbuch (16 seiten)

Seite drucken

Step 4

Step 5

Step 6

Step 7

Caution

them. The sides of the SIMM must clear the metal clasps before the SIMM can be safely removed.

Step 8

Step 9

Step 10

Inserting Shared Memory SIMMs

Take the following steps to insert shared memory SIMMs:

Step 1

Step 2

Step 3

Step 4

Step 5

Caution

shorted by mishandling.

Step 6

Remove and safely store all the network processor modules present, as described in

"Removing Network Processor Modules" on page 8, for later reinstallation.

Locate the shared memory SIMM card socket on the left of the motherboard, as shown in

Figure 8.

Turn the chassis so you are facing the rear of the chassis.

The SIMMs are held in place at each end by small metal spring clasps. To remove a shared

memory SIMM, push the two metal clasps apart. Angle the SIMM upward and pull it out.

Do not exert pressure on the components on the SIMM surface because you might damage

Place the removed SIMM in an antistatic bag to protect it from ESD damage.

Repeat Step 7 and Step 8 for each SIMM.

Proceed to the next section, "Inserting Shared Memory SIMMs."

Unplug the chassis power cord and network connections.

Attach an ESD-preventive wrist strap and ensure that it makes good contact with your skin.

Connect the equipment end of the wrist strap to the metal back plate of the chassis, avoiding

contact with the connectors.

Remove the chassis cover as described in the section "Accessing the Internal Components

of the Router" on page 5.

On the left of the motherboard (as aligned in Figure 8), ﬁnd the shared memory SIMM card

socket locations. All the sockets should be empty. If they are not, remove the shared

memory SIMMs following the procedures in the previous section, "Removing and

Replacing Shared Memory SIMMs."

Turn the chassis so that the side with the shared memory SIMM cards is closest to you.

Handle SIMMs by the card edges only. SIMMs are sensitive components and can be

Hold the SIMM with the connector edge at the bottom, component side facing you, and the

polarization notch on the left. (See Figure 13.)

Upgrading Cisco 4500, Cisco 4500-M, Cisco 4700, and Cisco 4700-M Memory

Memory Replacement Procedures