CA.MI NEW ASKIR 118 BASIC Gebrauchsanweisung - Seite 10

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Medizinische Ausrüstung CA.MI NEW ASKIR 118 BASIC herunter. CA.MI NEW ASKIR 118 BASIC 15 Seiten.

SUPPORT BRACKET AND CHARGE
The device is supplied with support bracket, therefore, the NEW ASKIR 118 BASIC suction unit can be fixed to the rescue means,
in compliance with the standards of reference. This bracket is equipped with electrical cable connected to the 12V
supply source of the ambulance and allows the internal battery of the suction unit to be charged.
The bracket must be installed in compliance with the indications provided in this manual. Failure to comply with such
warning may compromise the conformity to standard EN 1789 (design and construction of medical vehicles) and
significantly reduce the safety of the medical device;
Never alter mechanical, electrical, and structural parts of the bracket. These interventions make the device dangerous and,
therefore, they preclude its use;
The support bracket of the NEW ASKIR 118 BASIC device consists of a plastic part (ABS) and a seal hook, which allows the
suction unit to be fixed safely and easily. The figure below shows the bracket complete in all its parts.
The electrical cable of the bracket has double insulation and it must always be connected to an electrical source (12 V) of the
ambulance. Connection to the power supply source must always comply with the polarity.
In case of incorrect connection, the internal battery cannot be charged.
NOTE: The operations required to fix the bracket are described in the manual (30751/143 - rev.0 dated 15.05.2018), which is available
to the installation service of the medical vehicle.
The electrical connections must always be performed by qualified and authorised personnel. Connections must
never be entrusted to unauthorised personnel.
Even if voltage is only 12V
SECURING THE NEW ASKIR 118 BASIC SUCTION UNIT
The support bracket has been designed and manufactured only to fix and charge the NEW ASKIR 118 BASIC suction unit; no
other device can be secured to this system.
The seal efficiency and charge of the device is guaranteed only for this surgical suction unit model.
Insertion and extraction operations of the suction unit:
Take the NEW ASKIR 118 BASIC suction unit;
Place the device on the support bracket pulling the seal hook. Try to fit it inside the section on the bottom of the device;
Before removing your hands from the suction device, make sure that it is fixed correctly (pull the handle of the device
upwards and check the correct position of the device on the bracket);
To remove the suction unit from the bracket, pull the seal hook and remove the suction unit from the section on the bottom
of the device. Firmly hold the device and remove it from the bracket placing it in a safe point.
, short circuit may cause serious damage to persons and objects (risk of fire, etc.).
10
EN
power