Cisco Meraki MR76 Installationshandbuch - Seite 18

Blättern Sie online oder laden Sie pdf Installationshandbuch für Drahtloser Zugangspunkt Cisco Meraki MR76 herunter. Cisco Meraki MR76 27 Seiten.

3. Plug the Ethernet cable into the Ethernet port of the Meraki MR76.

a. Connect the cable to the Ethernet port on the MR76.

b. Screw the gland body into the threaded hole of the port. Use an adjustable wrench to make sure the gland

body is fully seated in the hole.

c. Insert the split ring gasket into the gland body.

d. Screw the cap tightly onto the gland. You may need a wrench to fully tighten the cap, but take care not to

damage the cable in the process.

Powering the MR76 with the Meraki 802.3at Power over Ethernet Injector (sold

separately)

1. Plug the power cord into the PoE Injector and the other end into wall power.

2. Plug an Ethernet cable that is connected to an active Ethernet connection into the "IN" port on the injector.

3. Route Ethernet cable from the "OUT" port on the injector to the PoE labled port in the cable bay of the MR76.

MR76 requires only 802.3af power to operate in normal mode.

Verify Device Functionality and Test Network Coverage

1. Check LEDs

a. The Power LED should be solid green (or blue, if clients are connected). If it is ﬂashing blue, the ﬁrmware is

automatically upgrading and the LED should turn green when the upgrade is completed (normally within a

few minutes). See the

b. Note: Your MR76 must have an active route to the Internet to check and upgrade its ﬁrmware.

2. Verify access point connectivity

a. Use any 802.11 client device to connect to the MR76 and verify proper connectivity using the client's web

browser.

3. Check network coverage

4. Conﬁrm that you have good signal strength throughout your coverage area. You can use the signal strength meter

on a laptop, smart phone, or other wireless device.

Reference the

MR Product Page

Support and Additional Information

If issues are encountered with device installation or additional help is required, contact Meraki Support by logging in to

case by visiting the Get Help section.

"LED

Indicators" section for more details. .

for additional information and troubleshooting tips.

dashboard.meraki.com

and opening a