Cisco PIX 506E Schnellstart-Handbuch - Seite 9

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Netzwerk-Hardware Cisco PIX 506E herunter. Cisco PIX 506E 17 Seiten. Chapter 3
Auch für Cisco PIX 506E: Schnellstart-Handbuch (18 seiten), Benutzerhandbuch (8 seiten)

Seite drucken

Follow these steps to use an activation key:

Ensure that the image in Flash memory and the Running Image are the same.

Step 1

Step 2

Make sure that you are in config mode to enter a new activation key.

From the CLI, enter the activation-key activation-key-four-tuple command, replacing

Step 3

activation-key-four-tuple with the activation key obtained from Cisco.

Reboot the PIX Firewall by powering it off and then on again.

Step 4

After the key update is complete, the system reloads to update the running image.

Restore the Default Configuration

You can restore your configuration back to the factory default values in one of the following ways:

• You can start the Startup Wizard at: https://192.168.1.1/startup.html

• Enter the following CLI commands:

Command

configure factory-default [<inside

Step 1

ip address> [address mask]]

write memory

Step 2

If the optional inside IP address and optional address mask are specified, the factory-default configuration

will reflect the specified IP address.

Entering the configure factory-default command erases the current running configuration.

Caution

Refer to the following website for detailed command information and configuration examples:

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v_62/cmdref/index.htm

The Cisco TAC website is available to all customers who need technical assistance. To access the TAC

Website go to:

http://www.cisco.com/tac

Description

Erases the running configuration and replaces it with

the factory default configuration.

Writes the factory default configuration to Flash

memory.