Cisco SCE 1000 and Schnellstart-Handbuch - Seite 36
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Netzwerk-Hardware Cisco SCE 1000 and herunter. Cisco SCE 1000 and 49 Seiten. Service control engine 1000 2xgbe
Seite drucken
Single Link: Receive-only Topology
In this topology, an external optical splitter resides physically on the GBE link between the subscriber side and the network side.
The external splitter is connected to the SCE 1000 via Rx links only.
In this topology, the traffic passes through the external splitter, which splits traffic to the SCE 1000. The SCE 1000, therefore,
is in receive-only topology, having only traffic monitoring capabilities.
Receive-only topologies can also be implemented using a switch. Such a switch must support SPAN functionality that
Note
includes separation between ingress and egress traffic and multiple SPAN-ports destinations.
Figure 17
External Splitting Topology
PWR A
PWR B
STATUS
BYPASS
Subscriber
Cabling the Line Interfaces
• Configure GigabitEthernet Auto-Negotiation, page 36
• Connect the GBE Line Interface Ports, page 37
Configure GigabitEthernet Auto-Negotiation
By default, the SCE 1000 GBE line interface ports are configured with auto-negotiation disabled.
If you change any parameters, you must save the new configuration settings. Type copy running-config startup-config,
Note
and press Enter.
Step 1
At the SCE 1000# prompt, type
Enters Global Configuration Mode.
At the SCE 1000(config)# prompt, type
Step 2
Enters the GigabitEthernet Interface configuration mode for the specified GBE port.
Portnumber is the number of the selected port (1 or 2).
36
LINK RX TX
LINK RX TX
RX
MM
TX
RX
MM
GBE-1
SUB
LINE
NET
Optical
Router
splitter
configure
interface GigabitEthernet 0/ portnumber
Cisco SCE 1000
2xGBE
TX
Router
and press Enter.
Series
Network
, and press Enter.