Cisco TelePresence Server 7010 Anleitung zum Ersetzen Handbuch - Seite 8
Blättern Sie online oder laden Sie pdf Anleitung zum Ersetzen Handbuch für Netzwerk-Hardware Cisco TelePresence Server 7010 herunter. Cisco TelePresence Server 7010 23 Seiten. 600w ac-input power supply and fan tray replacement
Auch für Cisco TelePresence Server 7010: Installationsanleitung Handbuch (15 seiten), Installationshandbuch (14 seiten), Erste Schritte (16 seiten), Anleitung zum Ersetzen Handbuch (18 seiten)
Seite drucken
Replacing the Chassis
Tools and Parts Required
This section lists the tools and parts you will need to complete these replacement procedures. Have
the necessary tools on hand so that you can complete the replacement without interruption:
•
•
•
•
•
Replacing the Chassis
The RP, SP (or SSP), and RSP1 are required system components in their respective chassis; you must
shut down the system power before removing or installing any one of these three processor modules.
All interface processors support online insertion and removal (OIR); however, after installing an
interface processor on line, you must wait at least 15 seconds for the system to reinitialize the
interfaces before installing the next interface processor. Therefore, it is more efficient to leave the
power off until all components are moved into the new chassis, then start up the system and check
the entire installation.
If you are installing the new chassis in an equipment rack, proceed to the next section. Otherwise,
proceed to the section "Installing the Cable Management Brackets" on page 12.
8 Cisco 7010 and Cisco 7505 Chassis Replacement Instructions
To replace the chassis cover, you need a 3/16-inch, flat-blade screwdriver to loosen the captive
screws on the chassis cover panel
To install a replacement chassis, you need a number 1 Phillips and a 3/16-inch, flat-blade
screwdriver for the captive installation screws on the processor modules (most of the carriers use
slotted screws, but some use Phillips screws)
To install new cable management brackets or to move brackets from the existing chassis, you
need the following tools and parts (panhead screws are included with the brackets):
— Number 1 Phillips screwdriver
— Two cable management brackets
— Six M3 x 8-mm, Phillips panhead screws
If you will mount or replace the chassis in an equipment rack, you also need the following tools:
— Number 2 Phillips screwdriver
— 1/4-inch and 3/16-inch, flat-blade screwdrivers
— Two chassis ears
— Four M4 x 10-mm, Phillips flathead screws to secure the ears to the chassis
— Eight 10-32 x 3/8-inch, slotted binderhead screws to secure the chassis ears to the rack
Whenever you remove or install processor modules, have the following equipment on hand to
help prevent ESD damage:
— Antistatic mat or antistatic foam pad in case you need to put one of the processor modules
down
— Your own ESD-preventive strap or the disposable ESD strap that is included with all spares