Cisco Versatile Interface Processor (VIP6-80) (VIP6-80) Installations- und Konfigurationshandbuch - Seite 10
Blättern Sie online oder laden Sie pdf Installations- und Konfigurationshandbuch für Netzwerk-Hardware Cisco Versatile Interface Processor (VIP6-80) (VIP6-80) herunter. Cisco Versatile Interface Processor (VIP6-80) (VIP6-80) 40 Seiten. Versatile interface processor
Seite drucken
Traffic Management
The VIP6-80 supports the following:
•
•
Installation Prerequisites
This section provides installation prerequisites to ensure a successful VIP6-80 installation, and includes
the following sections:
•
•
•
•
•
•
Software Requirements
The minimum Cisco IOS Release requirements for VIP6-80 are listed in
information and support, refer to the modular configuration and modular command reference
publications in the Cisco IOS software configuration documentation set that corresponds to the software
release installed on your Cisco hardware.
You can access Cisco IOS software configuration and hardware installation and maintenance
Note
documentation on the World Wide Web at http://www.cisco.com. Translated documentation is available
at the following URL: http://www.cisco.com/public/countries_languages.shtml.
Table 6
VIP6-80 Minimum Software Release Requirements
VIP Release
VIP6-80
Hardware Requirements
The VIP6-80 is a single motherboard. It operates with the following:
•
Versatile Interface Processor (VIP6-80) Installation and Configuration Guide
10
Simple Network Management Protocol (SNMP) agent V1 (RFCs 1155–1157)
Management Information Base (MIB) II (RFC 1213)
Software Requirements, page 10
Hardware Requirements, page 10
Microcode Requirements, page 11
Tools and Parts Required, page 11
Agency Approvals, page 11
Safety Guidelines, page 11
Minimum Cisco IOS Supported Releases
Cisco IOS Release 12.0(22)S or later release of Cisco IOS Release 12.0 S
Cisco IOS Release 12.1(12)E or later release of Cisco IOS Release 12.1 E
Cisco IOS Release 12.2(12)T or later release of Cisco IOS Release 12.2 T
Cisco 7505, Cisco 7507, Cisco 7507-MX, Cisco 7513, Cisco 7513-MX, and the Cisco 7576 routers
with the Route Switch Processor (RSP1, RSP2, RSP4, RSP4+, RSP8, or RSP16); the RSP should
have at least 64 MB of DRAM
Table
6. For configuration
OL-5078-01