Cisco UCS B Series Upgrade-Handbuch - Seite 10
Blättern Sie online oder laden Sie pdf Upgrade-Handbuch für Server Cisco UCS B Series herunter. Cisco UCS B Series 21 Seiten. Blade servers
Auch für Cisco UCS B Series: Schnellstart-Handbuch (10 seiten)
Seite drucken
Cisco UCS Blade Server
Upgrade Scenario 1: UCSM and BIOS Earlier Than Version 2.2(2c), CPU Earlier Than Intel E5-2400 v2
This scenario assumes the following conditions:
•
•
•
In this case, use the following procedure to upgrade the server and CPUs.
Upgrade the Cisco UCS Manager software to version 2.2(2c) or later. The required server CIMC and
Step 1
BIOS are also included with the 2.2(2c) download bundle.
Use the procedures in the appropriate upgrade guide for Release 2.1 in the
Upgrade Guides
Use Cisco UCS Manager 2.2(2c) to upgrade and activate the server CIMC to version 2.2(2c) or later.
Step 2
Use the GUI or CLI procedures in the
Use Cisco UCS Manager 2.2(2c) to upgrade and activate the server BIOS to version 2.2(2c) or later.
Step 3
Use the GUI or CLI procedures in the
Disassociate the server in Cisco UCS Manager.
Step 4
Power off the server.
Step 5
Replace the CPUs with the Intel E5-2400 v2 Series CPUs.
Step 6
Use the procedures in the
Reinsert the server to the chassis.
Step 7
Wait for Cisco UCS Manager to automatically discover the server.
Step 8
Note
Perform a board controller activation by using the Cisco UCS Manager CLI interface. Use the following
Step 9
sequence of commands:
Note
Note
# scope server <chassis/server>
# scope boardcontroller
# show image
# activate firmware <boardcontroller version>.0 force
# commit-buffer
See also
Cisco UCS B-Series Servers Upgrade Guide for Intel E5-2600/E5 2400 v2 Series CPUs
10
The Cisco UCS Manager software is at a version earlier than 2.2(2c).
The server is at a BIOS/CIMC version earlier than 2.2(2c).
The server is using CPUs earlier than Intel E5-2400 v2 Series.
(depending on your current software version).
Blade Server Installation and Service Note
At this point, the Health LED of the server shows a critical fault and Cisco UCS Manager reports
a generic error message:
controller activation is required, as described in the next step.
The
command in the sequence below lists the board controller versions available for
show image
the server. Always activate the latest board controller image version when you use the
command.
activate firmware
The server automatically reboots after the
Sample Board Controller Activation Command Sequence, page
UCS Manager Install and Upgrade Guides.
UCS Manager Install and Upgrade Guides.
WILL_BOOT_FAULT: Sensor failure asserted
commit-buffer
UCS Manager Install and
for your server.
. This is because a board
command is executed.
15.
OL-28629-02