Cisco EVM-IPVS-16A Verbinden Sie - Seite 8

Blättern Sie online oder laden Sie pdf Verbinden Sie für Gateway Cisco EVM-IPVS-16A herunter. Cisco EVM-IPVS-16A 15 Seiten. Analog video gateway network modules

Seite drucken

How to Install, Connect, or Replace the EVM-IPVS-16A Network Module

Connecting the EVM-IPVS-16A Network Module to the Network

This section describes how to connect the EVM-IPVS-16A network module to devices in the video

surveillance network.

Note

If an installation technician has already connected the EVM-IPVS-16A to the devices in your network,

then do not perform this task. Instead, proceed directly to the software configuration for your

EVM-IPVS-16A network module. See the Cisco Analog Video Gateway 1.0 Installation and Upgrade

Guide at:

http://www.cisco.com/en/US/docs/video/cavg/cavginstall/cavginstall.html

Prerequisites

•

Steps

To connect the EVM-IPVS-16A network module to the network, follow these steps:

Take the DB-37 end of the provided DB-37 to BNC video breakout cable, and connect it to the VIDEO

Step 1

connector on the EVM-IPVS-16A network module.

Connecting Cisco Analog Video Gateway Network Modules to the Network

Install the EVM-IPVS-16A network module in the router chassis. See the Installing Cisco Network

Modules in Cisco Access Routers guide at:

http://www.cisco.com/en/US/docs/routers/access/interfaces/nm/hardware/installation/guide/InstNe

tM.html

Wire the provided terminal block connectors. See the

section on page

Connecting Cisco Analog Video Gateway Network Modules to the Network

"Wiring the Terminal Block Connectors"