Cisco VG202 Software-Konfigurationshandbuch - Seite 28
Blättern Sie online oder laden Sie pdf Software-Konfigurationshandbuch für Gateway Cisco VG202 herunter. Cisco VG202 50 Seiten. Voice gateways
Auch für Cisco VG202: Hardware-Installationshandbuch (50 seiten), Handbuch (10 seiten), Hardware-Installationshandbuch (48 seiten), Schnellstart-Handbuch (19 seiten)
Seite drucken
Configuring the Voice Interface
Configuring the Voice Interface
Whenever you install a new interface or want to change the configuration of an existing interface, you
must configure the interface.
The Cisco VG202 and Cisco VG204 voice gateways are fixed voice gateways and do not support
Note
interface cards.
Before you configure an interface, have the following information available:
•
•
Timesaver
Obtain this information from your system administrator or network plan before you begin configuring
your Cisco VG.
To configure a voice interface, you must use configuration mode (manual configuration). In this mode,
you can enter Cisco IOS commands through the command-line interface (CLI).
To configure the voice interface configuration mode, follow these steps:
Step 1
Connect a console to the Cisco VG. If you need instructions for connecting a console, see the installation
chapter of your Cisco VG installation and configuration guide.
Step 2
Power on the Cisco VG. If the current configuration is no longer valid, after about one minute you see
the following prompt:
Would you like to enter the initial dialog? [yes/no]:
Answer no. You now enter the normal operating mode of the Cisco VG.
Note
Step 3
After a few seconds, you see the user EXEC prompt (
mode:
VG> enable
Password: < password >
The prompt changes to the privileged EXEC (enable) prompt (
VG#
Enter the configure terminal command to enter configuration mode:
Step 4
VG# configure terminal
VG(config)#
The Cisco VG enters global configuration mode, indicated by the
If you have not configured the Cisco VG before, or you want to change the configuration, use Cisco IOS
Step 5
commands to configure global parameters, passwords, network management, and routing protocols. In
this example, IP routing is enabled:
Cisco VG202 and Cisco VG204 Voice Gateways Software Configuration Guide
4-2
Protocols you plan to route on the new interface
IP addresses, subnet masks, network numbers, zones, or other information related to the routing
protocol
If the current configuration is valid, you enter the normal operating mode automatically.
Chapter 4
). Type enable and the password to enter enable
VG>
):
VG#
VG(config)#
Configuring Voice
prompt.
OL-16191-01