Epson FX-870 Spezifikationen - Seite 8
Blättern Sie online oder laden Sie pdf Spezifikationen für Drucker-Zubehör Epson FX-870 herunter. Epson FX-870 12 Seiten. Commonly asked questions and answers
Auch für Epson FX-870: Produkt-Support-Bulletin (20 seiten), Produkt-Support-Bulletin (5 seiten), Montageanleitung (8 seiten), Produkt-Support-Bulletin (16 seiten), Produkt-Support-Bulletin (8 seiten)
Seite drucken
FX-870/1170
Auto carriage return
the auto carriage return is valid, each line feed (LF)
When
code or ESC J (n/216-inch line feed) code is always
accompanied by a carriage return (CR) code. The printer
always
the next print position to the left margin when
moves
it receives the LF or ESC J code. When this feature is invalid,
you must send the CR code after the line feed code to move
the print position to the left margin. This feature is available
in IBM emulation mode only.
Changing Group 1 default settings
1. Make sure the printer is turned off,
2. Turn on the printer while you hold down the
This enters the Group 1 default setting mode. The printer
beeps several times.
3. Load single-sheet or continuous paper. The printer then
automatically loads the paper and prints a quick reference.
Group 1 default settings
FONT COND. Feature
light
ON
BLINK Skip-over-
perforation
BLINK OFF
Shape of Zero
BLINK ON
Tear off
BLINK
BLINK Auto line feed
FONT
CONDENSED lights show
The
and
have button as many times as necessary until the
CONDENSED
and
lights match your selection.
For example, if you want to change the character spacing,
FONT
press the
button until the
is blinking.
PAUSE
Next, press the
READY
light shows your selection.
For example, if you want to change to 12 cpi, press the
PAUSE
button once to turn the
If necessary, repeat this process for any other Group 1
features you want to change.
Exit the Group 1 default-setting mode at any time by
turning off the printer. Any changes you have made
remain in effect until you change them again.
FX-870/1170-8
FONT
READY
light
BLINK
No skip
OFF
Skip 1 inch
ON
0
OFF
ON
Valid
OFF
ON
on
OFF
Valid
which feature you
FONT
light is off and the
button to change the setting. The
READY
light on.
If
you want to check the new default settings, enter the
Note:
turn oftke printer to exit the default-setting mode.
Changing Group 2 default settings
1. Make sure the printer is
2. Turn on the printer while you hold down the
PAUSE
mode. The printer beeps several times.
3. Load single-sheet or continuous paper. The printer then
automatically loads the paper and prints a quick reference
according to the emulation setting in Group 1.
button.
IBM mode character table
Press the
FONT, CONDENSED
FONT
to show your selection.
For example, if you select PC437 (USA, standard Europe),
FONT
the
READY light
After you have made your selection, exit the Group 2
default-setting mode by turning off the printer.
Note:
you want to check the new default settings, enter the
turn ofthe printer to exit the default-setting mode.
10/13/98
buttons. This enters the Group 2 default-setting
FONT
button to select the character table. The
READY lights
and
CONDENSED
light is on, the
is off.
that,
FONT
and
light is off, and the
9-Pin Printers