3Com Router 3032 Freigabemitteilung - Seite 7

Blättern Sie online oder laden Sie pdf Freigabemitteilung für Netzwerk-Router 3Com Router 3032 herunter. 3Com Router 3032 9 Seiten. 3000 dsl series
Auch für 3Com Router 3032: Freigabemitteilung (7 seiten), Datenblatt (4 seiten), Datenblatt (4 seiten), Datenblatt (4 seiten)

Seite drucken

MPLS

Documentation Errors

Frame Relay Congestion Control BECN/FECN does not function. Disable IP Fast

Forwarding on the interface if Frame Relay Traffic Shaping is selected.

Frame Relay Traffic Shaping is Inactive on interfaces that use Frame Relay Traffic

Shaping. Disable IP Fast Forwarding on the interface if Frame Relay Traffic

Shaping is selected.

QoS with ip fast forwarding doesn't work properly. Disable ip fast forwarding.

If you ping a CE Router from a PE Router within an MPLS/BGP L3 network there

will be no response. Use the command

, using the source address of the PE interface that is in the

xxx.xxx.xxx.xxx

VPN of the intended target.

If Loopback0 and LSR ID ip addresses are different, MPLS LDP will not work

properly. Match Loopback0 and LSR ID ip addresses

Command Reference Manual' IS-IS section text is:

"When the cost type is "narrow", its range is 1 through 63; when the cost type

is wide, its range is 1 to 16777215."

Text Correction: "When the cost type is "narrow", its range is 0 through 63;

when the cost type is wide, its range is 0 to 16777215."

The Router 6000 Family uses the frame relay terminology Cir Allow and Cir,

instead of Cir and MinCir respectively. Please refer to the following documents:

'3Com Router Command Reference Manual' page 1033. '3Com Router

Configuration Guide' page 1019

Text Correction: Use CIR Allow when configuring the maximum Committed

Information Rate for the DTE when no network congestion exists. Use CIR as

the value to which the DTE will adjust when network congestion exists

Command manual example results in an error: "snmp-agent local-engineid

12345"

Text Correction: The command requires the user to enter a string of 5 to 32

octets of hexadecimal characters for the SNMP engine ID. Ex: 0102030405

The

command is non-existent in the Command Index.

virtualbaudrate

Use the "virtualbaudrate" command in the CLI.

[6080-3-Serial2/0/4]virtualbaudrate?

300

only for async mode

600

only for async mode

1200

for syn & asyn mode

2400

for syn & asyn mode

4800

for syn & asyn mode

9600

for syn & asyn mode

19200

for syn & asyn mode

38400

for syn & asyn mode

56000

only for syn mode

57600

for syn & asyn mode

64000

only for syn mode

72000

only for syn mode

115200

for syn & asyn mode

128000

only for syn mode

384000

only for syn mode

2048000

only for syn mode

ping -vpn -a xxx.xxx.xxx.xxx

MPLS