Acuity Controls Fresco VIA5F Benutzerhandbuch und Handbuch - Seite 2

Blättern Sie online oder laden Sie pdf Benutzerhandbuch und Handbuch für Netzwerk-Router Acuity Controls Fresco VIA5F herunter. Acuity Controls Fresco VIA5F 3 Seiten.

Seite drucken
User Guide and Manual
VIA / VIA5F Ethernet Switch Installation
OVERVIEW
The VIA5 and VIA5F gigabit Ethernet switch is
a DIN-mountable, managed switch suitable for
use in entertainment lighting, audio and video
distributions systems. Ideal for use in NEMA
enclosures and as a Power-over-Ethernet
source for connected equipment, such as DXT
DMX/Ether-net gateways, Fresco Show DTP
lighting consoles and Fresco Show WM archi-
tectural controllers.
CONNECTIONS
The VIA5 and VIA5F models feature terminal strips that can
be removed from the card to facilitate easy wiring for power.
Power
The VIA5 and VIA5F are designed to run on a 100W, 48VDC
power supply to ensure the availability of Class 3 PoE on
each of the RJ45 Ethernet ports.
Observe polarity when connecting V+ and V-. A second set
of terminals are provided so power may be daisy-chained to
other VIA5 switches or other Pathport DIN-mountable nodes.
Do not connect 48VDC to DXT inter-face cards that do not sup-
port 48V. The EARTH GROUND terminal must be connected
to the enclosure's chassis or electrical ground terminal to
ensure EMC compliance.
Ethernet
All network wiring should follow standard Ethernet rules
and be installed by a qualified person. As part of the instal-
lation, all wiring should be certified under the TIA/ EIA-568
standard.
Acuity recommends the use of manufactured rather than
hand-terminated cables. We also recommend terminating
building wire to a female RJ45 cage, and using a male to
male jumper to connect the wiring to the switch.
Acuity Brands | One Lithonia Way Conyers, GA 30012 Phone: 800.535.2465 www.acuitycontrols.com © 2014-2017 Acuity Brands Lighting, Inc. All rights reserved. 07/03/17
Part No. 912-00014-011
INSTALLATION
Disconnect all power before proceeding with installation.
Securely mount DIN rail (if not already installed in the
en-closure). Hook the upper slots on the back of the plastic
extrusion to the DIN rail and then gently but firmly press on
the bottom front corners of the extrusion to snap the module
onto the rail. Do NOT press directly on the PCB card itself.
Connect the power terminal block, after checking that polar-
ity is being observed. The VIA5 will boot up, which may take
15-20 seconds.
Attach required network cables to the RJ45 ports. Connect
the fiber module, if used.
The system is now ready for configuration and testing.

STATUS INDICATORS

Red.
Processor
Blinks when VIA is powered up and processor is function-
ing
Red.
POE Status
Off: 48VDC input not present
(required voltage for PoE support). Blinking: 48VDC
input present, but not configured.
Steady: Functioning normally.
Identify
Blue.
Blinks when identify is active.
Fiber//Link
Amber.
Functional on VIA5F model only. Blinks when SFF module
Activity
has valid connected to another device.
RJ45 PORT STATUS INDICATORS
Link Activity
Amber.
Intermittent blinking indicates valid link to other device.
POE Status
Green.
Steady indicates PoE in use. Blinking indicates insuf-
ficient PoE available to power end device.
Page 2