Yamaha CX-1000 Benutzerhandbuch - Seite 14

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken Yamaha CX-1000 herunter. Yamaha CX-1000 20 Seiten. Natural sound stereo control amplifier
Auch für Yamaha CX-1000: Benutzerhandbuch (21 seiten), Benutzerhandbuch (20 seiten), Service-Handbuch (38 seiten)

Seite drucken

When selected with the REC OUT rotary switch, the signals of digitally

connected equipment are sent to the digital OUT terminals of the

connected DAT deck(s). However, when this switch is set to SOURCE

and the unit to be recorded is selected with the INPUT SELECTOR,

the signals of the respective source are sent to the analog OUT ter-

minals, even if the source is digitally connected.

NOTE:

It is not possible to record sources connected only via analog jacks

with DATs that are connected only to digital terminal.

1. Select the source from you wish to record with REC OUT selector.

2. To confirm the source, press the corresponding INPUT SELECTOR.

3. Activate the program source, adjust the recording level on your

deck(s), then start recording.

(If your tape deck nas three head

monitoring capability, you can listen to the sound just recorded by

choosing that deck with the INPUT SELECTOR.)

4. While recording, you can listen to or watch any other component

without influencing the quality of the recording simply by selecting

that component with the INPUT SELECTOR.

NOTE:

When recording with the REC OUT selector in the SOURCE position,

it is not possible to watch or listen to any input source other than

the recording source.

Dubbing, i.e. the copying of tapes or parts of tapes from one deck to

another, is performed in basically the same manner as normal source

recording. The REC OUT selector determines from which of two

connected decks the recording will be made.

1. Select the source tape deck with REC OUT.

2. To monitor the sound during recording, also select the corre-

sponding deck with the INPUT SELECTOR.

3. Start playback of the tape to be copied, adjust the recording level

on the other deck, then start recording.

(Again, ifthe recording tape

deck has three head monitoring capability, you can listen to the sound

just recorded by pressing the INPUT SELECTOR to choose that deck.)

4. During dubbing, you can listen to any other component without

influencing the quality of the recording by selecting that component

with the INPUT SELECTOR.

Any video source connected to the analog CDV1 (or CDV2) jacks car

be recorded with the VCRs, regardless of the INPUT SELECTOR

setting.

1. Set the REC OUT selector to CDV1 (or CDV2).

2. Set the VIDEO switch to ON.

3. Set the INPUT SELECTOR to CDV1 (or CDV2).

4. Set the VCR to the record mode, then start playback of the video

source.