Zanussi ZWS 58801 Benutzerhandbuch - Seite 14

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Waschmaschine Zanussi ZWS 58801 herunter. Zanussi ZWS 58801 21 Seiten.

Seite drucken

CLEANING THE INLET HOSE AND THE VALVE FILTER

FROST PRECAUTIONS

If the appliance is installed in an area where the

temperature can be less than 0° C, remove the

remaining water from the inlet hose and the drain

pump.

1. Disconnect the mains plug from the mains

socket;

2. Close the water tap;

3. Unscrew the water inlet hose from the tap;

4. Unscrew the water inlet hose from the back

appliance;

5. Place the two ends of the inlet hose in a bowl

and let water flow out of the hose;

6. Set the drain programme and let it operate until

the end of the cycle.

7. Turn the programme knob to

the appliance from the power supply.

8. When the drain pump is empty, install the

water inlet hose again.

WARNING! Make sure that the

temperature is more than 0 °C before

you use the appliance again.

The manufacturer is not responsible

for damages caused by low

temperatures.

TROUBLESHOOTING

WARNING! Refer to Safety chapters.

to disconnect

EMERGENCY EMPTYING OUT

If the appliance does not drain the water, to empty

out proceed as follows:

1. Disconnect the mains plug from the mains

socket;

2. Close the water tap;

3. If necessary, wait until the water has cooled

down;

4. Open the filter door;

5. Place a bowl on the floor below the recess of

the drain filter;

6. Press the two levers and pull forward the

drainage duct to let the water flow out;

The water should drain by gravity into the bowl.

7. When the bowl is full of water, put the drainage

duct back again and empty the bowl;

8. Repeat the procedure until water stops flowing

out;

9. If necessary, clean the pump as previously

described;

10. Put the drainage duct back;

11. Close the drain filter door.

INTRODUCTION

The start of the appliance does not occur or it

stops during operation.

45°

20°