Zanussi ZDT40 Benutzerhandbuch - Seite 19
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Geschirrspüler Zanussi ZDT40 herunter. Zanussi ZDT40 28 Seiten. Zanussi washer dryer brochure
Auch für Zanussi ZDT40: Spezifikationen (7 seiten)
Seite drucken
Fault code and malfunction
The programme does not start.
Once these checks have been carried out;
switch on the dishwasher. The programme will
continue from the point at which it was inter-
rupted.
If the malfunction or fault code reappears con-
tact the Service Force Centre.
For other fault codes not described in the above
chart, please contact your Service Force Cen-
tre.
Mod. :. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PNC : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
The dishes are not clean
The dishes are wet and dull
• The dishwasher door has not been properly closed.
• The main plug is not plugged in.
• The fuse has blown in the household fuse box.
The wash results are not satisfactory
• The wrong washing programme has been selected.
• The dishes are arranged in such a way as to stop
• The spray arms do not rotate freely due to incorrect
• The filters in the base of the washing compartment
• Too little or no detergent has been used.
• Where there are limescales deposits on the dishes;
• The drain hose connection is not correct.
• The salt container cap is not properly closed.
• Rinse aid was not used.
• The rinse aid dispenser is empty.
Possible cause and solution
Close the door.
Insert the mains plug.
Replace the fuse.
Contact your local Service Force Centre, quot-
ing the model (Mod.), product number (PNC)
and serial number (S.N.). This information can
be found on the rating plate located on the side
of the dishwasher door.. So that you always
have these numbers at hand, we recommend
you to make a note of them here:
water reaching all parts of the surface. The baskets
must not be overloaded.
arrangement of the load.
are dirty or incorrectly positioned.
the salt container is empty or the incorrect level of
the water softener has been set.
19