Zanussi ZFT 410W Gebrauchsanweisung - Seite 32

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Gefrierschrank Zanussi ZFT 410W herunter. Zanussi ZFT 410W 48 Seiten.

Seite drucken
GB
Some useful information and
advice
After opening and closing the door of freezer vacuum
will rise inside the appliance because of the low
temperature. So wait 2-3 minutes after closing the
door - if you want to open it again - while inner
pressure equalises.
Take care of operating the freezer at a position of
thermostatic control so that the inside temperature
can never go beyond -18 °C, since temperature
higher than this can deteriorate frozen foods.
It is practical to make sure of faultless operation of
the appliance daily so as to notice possible failure in
time and prevent deterioration of frozen foods.

Hints and ideas

In this chapter practical hints and ideas are given about
how to use the appliance to reach maximum energy
saving and there is environmental information about the
appliance as well.

How to save energy

Avoid putting the appliance in a sunny place and near
anything that gives off heat.
Be sure that the condenser and the compressor are
well ventilated. Do not cover the sections where
ventilation is.
Wrap products in tightly closing dishes or cling film to
avoid building up unnecessary frost.
Avoid products put in the freezer compartment to
touch foods already frozen.
Do not leave the door open longer than necessary
and avoid unnecessary openings.
Put warm foods into the appliance only when they are
at room temperature.
The condenser must be kept clean.

The appliance and environment

This appliance does not contain gasses which could
damage the ozone layer, in either its refrigerant circuit or
insulation materials. The appliance shall not be discarded
together with the urban refuse and rubbish. Avoid
damaging the cooling unit, especially at the rear near the
heat exchanger. Information on your local disposal sites
may be obtained from your municipal authorities.
The materials used on this appliance marked with the
sympol
are recyclable.

Maintenance

Defrosting

Bleeding part of the moisture of cooling chamber in form
of frost and ice goes with the operation of the appliance.
Thick frost and ice has an insulating effect, so it reduces
cooling efficiency as the temperature increases, it needs
more energy, at a certain thickness it does not allow the
door of the freezing compartment to open, possibly the
32
Downloaded from Fridge-Manual.com Manuals
door can be broken.
It is possible to scrape off and remove smaller frost and
ice with the enclosed ice scraper.
The tray in figure is not a piece of accessories to the
appliance!
When ice coating is so thick that it can not be removed
with the frost scraper defrosting is necessary. Its
frequency depends on usage.
How to defrost it:
Disconnect the appliance from the electrical supply. If the
plug is not accessible turn the temperature control knob
to "0" position.
Take the frozen foods out of the appliance and put them
into a basket lined with paper or cloth. Store them in a
possibly cool place or replace them into a frozen or fresh
food compartment of a refrigerator.
Leave the door open.
Sweep off the melting water occasionally with a cloth or
sponge in direction of sides which gathers in the outlet
channel practically formed in the bottom of the appliance
and can be removed as follows:
Put a tray high enough in front of the appliance. Insert the
plastic scraper into the defrost water outlet according to
the picture. Defrost water will flow into the tray through
the outlet.
Defrosting process can be made quicker by placing a pot
or dish filled with warm water to the cooling plate formed
as a shelf.
After defrosting wipe the surfaces and push defrost water
outlet back.
Apply voltage to the appliance.
Turn the temperature control knob to a medium position
and leave to run.
After the red light has gone out put the foods back.