AFTI WATCHDOG 2 Schnellstart-Handbuch - Seite 2

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Messgeräte AFTI WATCHDOG 2 herunter. AFTI WATCHDOG 2 2 Seiten. Changing the batteries and setting

Seite drucken

If the internal clock time was not successfully saved before the batteries were changed, you will need to

reset the clock using the following procedure.

1. Put Watch-DOG into Clock Set Mode:

Hold magnet at Target #3 while watching LEDs until they all flash orange and then remove the

magnet. LED #1 will now stay lit red.

(Note: the LEDs will flash green then red then orange while you hold the magnet at the target)

b. Hold magnet at Target #3 while watching LEDs until the remaining LEDs (#2 + #3) flash orange and

then remove the magnet. LED #1 will now stay lit orange.

Hold magnet at Target #3 while watching LEDs until the remaining LEDs (#2 + #3) flash orange and

then remove the magnet. LED #1 will now stay lit green. The Watch-DOG unit is now in clock set

mode.

(Note: the unit will return to normal operating mode after 1 minute if there is no further interaction

with the magnet and the targets)

2. Set the hours:

Hold the magnet at target #1 while watching LED #3. Each flash of the LED signifies a 1 hour

increment. The LED flashes red for AM and green for PM. Count the flashes until you reach the

desired set time, then remove magnet. The LED will then flash corresponding to the current set

hours. If you need to add additional hours to the clock, hold the magnet at the target until you add

the number of hours desired. Please set the clock hours to local standard time.

3. Set the minutes:

Hold the magnet at target #2 while watching LED #2 (middle LED). Each flash counts as an increment

of 5 minutes. The count starts at zero whenever the LED changes color. Count the flashes until you

reach the desired set time, then remove magnet. The LED will then flash orange for each 5 minute

increment. If you need to add additional 5 minute increments to the clock, hold the magnet at the

target until you add the number of increments desired.

4. Save the time:

You must exit the Clock Set Mode and save the clock settings by swiping the magnet across target #3.

5. Confirm the time:

You can confirm the clock setting by holding the magnet at target #3 for 3 seconds (watch the LEDs,

they will change from green to red). Remove the magnet and count the flashes displayed on the

LEDs. Hours will flash first (red = AM and green = PM) on LED #3, flowed by LED #2 flashing orange

the number of 5 minute increments.

Example:

To set the hour to 4:25 PM, hold the magnet at the target until you count 5 successive green flashes (corresponding to 12, 1, 2,

3, 4 PM). When you remove the magnet, the LED will flash green 4 times (corresponding to 1,2,3,4 PM). Then hold the magnet

at target 2 until you see 6 successive flashes of the same color (corresponding to 0, 5, 10, 15, 20, 25), then remove the magnet

from target #2. LED will flash 5 times (5x5 = 25). Swipe the magnet across target #3 to save the changes.

______________________________________________________________________________

Setting the Watch-DOG 2 Internal Clock