3D Upfitters LulzBot Mini 2 R1 Installationshandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Installationshandbuch für 3D-Drucker 3D Upfitters LulzBot Mini 2 R1 herunter. 3D Upfitters LulzBot Mini 2 R1 18 Seiten. Enclosure kit

Seite drucken

Note there are also mid-panel connectors on the top and left

and right sides of the door frame. These should be attached

using M4 cap head 12mm screws.

3. Assemble Latch Mount

Locate the magnetic latch and use the wood

screws to attach it to the latch mount. Hand

tighten and make sure its secure, but do not

over tighten or the screws may strip. The latch

can be later adjusted front-to-back to make sure

the door is ﬂush with the door frame.

The assembled latch mount is attached to

the door frame via two M4 12mm cap head

screws at the bottom of the door frame as

shown to the right.