AluTeam BR 13x-3 Montageanleitung Handbuch - Seite 12

Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Trucks AluTeam BR 13x-3 herunter. AluTeam BR 13x-3 14 Seiten. Box kits

Seite drucken

Adapter

Suitable for motor vehicle type:

cable

MB Sprinter, VW Crafter, MAN TGE,

Opel Movano, Renault Master, Citro-

MA350158

en Jumper, Fiat Ducato,

MA350159

MA350168

Attention: Paints, solvents

and dusts endanger health.

Protect yourself!

Assembly instructions BR 133-3 to 139-3

Peugeot Boxer

Iveco Daily

Ford Transit

Fig. 396

Fig. 397

Fig. 398

Fig. 399

•

Pull out the connection cable for the interior lights at the bottom

of the left frame pillar and connect to the vehicle electrics.

Attention:

Follow the instructions of the vehicle manufacturers!

•

Pull out the connection cable for the navigation lights and, if ap-

propriate, the connection cable of the side marking lights at the

bottom of the right frame pillar. Connect these connection cables

to the adapter cable for the respective vehicle.

•

Connect the vehicle-specific adapter cable with the rear light

(Fig. 396).

•

Check the roof corners, doors and the lighting for tightness e.g. by

a water test for structures, following EN 283.

For this, direct a water jet from a ½" nozzle (Ø 12.5 mm inner di-

ameter) at a pressure of over 1 bar onto the external sealed joints.

Hold the nozzle at a distance of approx. 1.5 m from the structure.

After the test, no water should have penetrated into the structure.

•

You can generally paint over our coil coating and powder-coated

parts with traditional wet paints. For a secure adhesion, get in

touch with the paint supplier especially concerning the primer.

Untreated and zinc-coated profiles are to be treated with a suitable

primer before painting. The temperature in the painting cubicle

may not exceed 60°C.

•

Pay attention in particular to the corrosion protection in case of

subsequently attached component parts or modified AluTeam com-

ponents. In particular, you must absolutely exclude contact corro-

sion through different materials (Fig. 398). Otherwise the guaran-

tee on the painting, coating and bond is voided.

Note that the final strength of the sealant is reached, at the

earliest , after 24 hours (at 20°C). The assembled box can be treat-

ed but not loaded.

Attention:

You may only clean the structure with a steam

cleaner after 6 weeks. Please absolutely consider the

corresponding explanations under "4. Maintenance".

Stick-on labels related to the structure strength apply only in

connection with a certificate issued by AluTeam (Fig. 399).

Status 03/2022

Former instructions lose their validity.

12 / 14