ALUZ A1-ZIBI-PVT-RGBW Handbuch - Seite 5

Blättern Sie online oder laden Sie pdf Handbuch für Beleuchtungsanlagen ALUZ A1-ZIBI-PVT-RGBW herunter. ALUZ A1-ZIBI-PVT-RGBW 11 Seiten. Pivot rgbw

Measure area where luminaire will be installed. Use a laser line to create a

reference along installation area, ensuring accurate placement of mounting

clips. Mark location where each mounting clip will be installed along

reference line.

The number of required mounting clips differs for dry and wet location

products. Verify number of mounting clips is appropriate for installation

environment before beginning installation. Do not install luminaires with

inadequate number of mounting clips. Refer to the Mounting Clips page for

additional information.

Lay mounting clips along reference line and pre-drill surface using an

appropriate drill bit for surface and screw size.

Recommendation: 8/32 x 1" Screw.

Note: Allow 1/4" clearance for lateral expansion of assembled mounting clips.

Only install mounting clips on flat, even surfaces.

If applicable, connect disconnects between luminaire segments. Slide

shrink tube over connectors and apply heat. The shrink tube will shrink

down, sealing the connectors. Apply silicone around sealed connectors for a

stronger seal.

Note: Only use a heat gun to apply heat to shrink tubes. Do not use an open

flame such as a lighter or gas torch.

1170 N Red Gum St, Anaheim, CA 92806

aluz.lighting

A1 Series | Surface

ZIBI Pivot RGBW

(A1-ZIBI-PVT-RGBW)

Shrink Tube

Apply Heat

866.ALUZ.LTG | 714.535.7900

Screw MC-1 mounting clips to surface, then snap luminaire into mounting

clips. Install set screws if required. Set screws are required for downward and

outward facing applications.

Set Screw

Perform a continuity test before connecting luminaire to power source.

Refer to Troubleshooting & Continuity Test page for additional information.

Verify wiring diagram, then connect luminaire to power source.

Page 5 of 11

Mounting

Installation Instructions

4 / 29 / 2022 / Rev 2