Dog trace d-balls Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Handbuch für GPS Dog trace d-balls herunter. Dog trace d-balls 11 Seiten. Electronic ball dropper

BATTERY INSTALLATION AND REPLACEMENT

Installation (replacement) of the battery in the ball dropper

Remove the screw from the ball dropper battery space cover with a cross-head screwdriver.

Take the battery holder out carefully. Insert 4 LR6 AA 1,5V batteries. Mind the polarity

marked on the battery holder.

Before putting the battery space cover back to its place make sure that the battery holder

is seated in the battery space correctly. Tighten the screw on the battery space cover using

adequate force.

Battery space cover

Checking the battery status

Look at the indicator light on the front panel of the ball dropper to check the battery status:

The battery is fully charged: the LED indicator blinks slowly in green in on-state.

The battery is weak: the LED indicator blinks in red in on-state. Prepare 4 spare LR6 AA 1.5

V batteries and follow the previous paragraph Installation of the battery in the ball

dropper.

TIP: The device can also be operated using LR6 rechargeable batteries.

Installation (replacement) of the battery in the

remote controller

Unscrew the battery space cover screw on the back side

of the remote controller and litt the cover carefully. Insert

a new 3V CR2 battery. Mind the polarity marked on the

battery cover (see the picture). Put the cover back and

tighten the screw using adequate force.

When the battery gets weaker, the remote controller

performance (radio signal coverage) decreases. The

battery needs to be replaced. Discharged battery is

indicated by red LED diode which is lit up by pressing any

button on the remote controller. Prepare a spare battery

and follow the instruction above for replacing batteries in the remote controller.

TIP: You can remove the batteries more easily using a small screwdriver inserting it

carefully under the edge of the battery.

Make sure the remote controller is working correctly. By pressing any button, the green

LED diode lights up.

Battery holder

Battery compartment