Akron 3579 Einbauanleitung

Blättern Sie online oder laden Sie pdf Einbauanleitung für Messgeräte Akron 3579 herunter. Akron 3579 5 Seiten. Stop bracket service kit

FIELD INSTILLATION INSTRUCTIONS FOR STYLE 3579

Kits Contents:

#160 (X2): 1/4"-20x1.5" Stainless steel socket head cap screw

#202 (X1): 1/2"-20 Stainless steel plug

#203 (X1): Stop bracket assembly

#206 (X1): 1/2"-20x1/2"Stainless steel hex head cap screw

Disassembly:

1. Move the elevation joint to a position a few degrees off vertical

2. Remove the plug (#202) from the uppermost hole on the inlet elbow (#2) using a ½" socket or wrench.

Refer to Figure 1.

3. Remove the permanent stop (#127) and lock washer (#170) from the middle hole on the inlet elbow

using a ¾" socket or wrench. Refer to Figure 1.

4. Inspect the area around the hole from which the permanent stop was just removed for any visible cracks or

damage. If cracks or damage are present it is recommended that the unit be returned to Akron Brass for repair.

5. If monitor looks acceptable after step 4, rotate elevation joint so that it is at 45° from vertical.

6. Proceed to remove both cap screws (#161) holding the elevation gear cover(#7) to the inlet elbow

casting, using a 3/16" Allen wrench.

Figure 1: Part Removal

STOP BRACKET SERVICE KIT

202

170

127

127151

#202

#160

161

#206

#203