Asko TD75 Installationsanweisungen und Bedienungsanleitungen - Seite 10
Blättern Sie online oder laden Sie pdf Installationsanweisungen und Bedienungsanleitungen für Trockner Asko TD75 herunter. Asko TD75 12 Seiten. Condenser tumble dryer
Auch für Asko TD75: Installationsanleitung Handbuch (13 seiten)
Seite drucken
1. Turn the power off at the breaker or fuse box.
2. Remove terminal block cover.
3. Use the strain relief attached below the terminal
block opening.
4. Loosen or remove center terminal block screw.
6
5. Connect ground (center) wire of power supply
cord to the center, silver-colored terminal screw.
Tighten screw.
6. Connect the other wires to outer screws.
7. Tighten the strain relief screws.
8. Replace terminal box cover on back of dryer.
9. Plug dryer into wall receptacle.
10.Turn power on at breaker/fuse box.
Connecting a 4-wire Power Cord
Before starting this procedure, be sure the
power is turned off at the breaker/fuse box.
4-Wire Cord
Neutral
Ground
prong
10
Spade terminals with
upturned ends
3/4" UL-listed
Ring
strain relief
terminals
Neutral
(White)
Ground
(green)
Customer Care Center, 1-800-898-1879, www.askousa.com
Power Supply Cord
You will need a 4-wire power supply cord with
four No. 10 copper wires and a matching 4-wire
receptacle of NEMA Type 14-30R, as illustrated
below. The fourth wire must be identifi ed with a white
cover and the ground conductor by a green cover.
To connect a 4-wire power cord to the dryer, follow
4
the steps below.
The numbers in the illustration correlate to the
step numbers.
5
1. Turn the power off at the breaker/fuse box.
2. Remove terminal block cover.
3. Use the strain relief attached below the terminal
block opening.
4. Remove center terminal block screw.
6
5. Remove ground wire (green with yellow stripes)
from external ground connector screw and
remove from center terminal block.
6. Connect ground (green) wire of cord to external
ground conductor screw.
7. Connect neutral (white) wire of cord under center
screw of terminal block.
8. Connect the other wires to outer screws.
9. Tighten the strain relief screws.
10.Replace terminal box cover on back of dryer.
11.Plug dryer into wall receptacle.
12.Turn power on at breaker/fuse box.
4
7
8