AME Intl. 11001 Manual de instrucciones - Página 6

Navegue en línea o descargue pdf Manual de instrucciones para Equipamiento industrial AME Intl. 11001. AME Intl. 11001 6 páginas. Aluminum otr 5 piece bead

Imprimir página

Inspecting the Tire and Rim

Always replace damaged or badly worn tires. When replacing tires, always use a replacement of

exactly the same diameter. Destroy old tires, so that they cannot be used. Using badly worn or

damaged tires can result in serious injury or death.

1. Inspect all rim parts for damage.

Always replace rim parts that are bent, badly rusted, pitted from corrosion, cracked, worn, or dam-

aged. Destroy old rim parts, so they cannot be used. Using damaged rim parts can result in seri-

ous injury or death.

Do not mix parts from one rim with parts from another rim. Always use replacement parts that You

can positively identify as the CORRECT replacement parts. All replacement rim parts MUST match

the replacement part numbers stamped on the rim parts, Rims with different part numbers cannot

be interchanged. If in doubt about sizing, DO NOT reassemble the rim. Contact the rim manufac-

turer for more information.

2. Replace damaged Parts

Never weld on an inflated or partially inflated tire/rim assembly. Welding on an inflated tire/rim as-

sembly can cause an explosion and serious injury or death.

Do not rework, weld, heat or braze any rim parts for any reason. Reworking and welding damaged

parts can result in serious injury or death.

3. Clean and repaint rim parts as necessary.

NOTE: Remove rust, dirt and foreign material from rim parts. Repainting the rim parts and bare metal areas will

make them last longer. Be careful to keep paint out of the lock ring groove in the gutter when repainting rim

parts.

4. Visually inspect all tire and rim parts to make sure they are positioned properly.

AME INTERNATIONAL

INSTRUCTION MANUAL

- 6 -