AMEO POWERBREATHER PB01 Manual - Página 4

Navegue en línea o descargue pdf Manual para Instrumento de buceo AMEO POWERBREATHER PB01. AMEO POWERBREATHER PB01 9 páginas.

WARNING AND SAFETY NOTES

WHAT YOU NEED TO KNOW FOR SAFETY

THE POWERBREATHER IS FOR ADULT USE ONLY.

CHILDREN SHOULD NOT USE THE POWERBREATHER

WITHOUT ADULT SUPERVISION.

/ / DO NOT USE the POWERBREATHER for diving. The POWERBREATHER is

only intended for swimming and snorkling.

/ / The POWERBREATHER is intended for experienced swimmers. The

POWERBREATHER is not suitable for non-swimmers and does not provide

protection against drowning.

/ / Prior to each time you put on the POWERBREATHER, check to make sure

that the system and all of its components are free from foreign particles.

/ / Do not use the POWERBREATHER under the influence of alcohol, drugs or

medications that could impair your awareness or responsiveness.

/ / Do not modify the POWERBREATHER or any of its components. This could,

under certain circumstances, endanger safety or even your life.

/ / In the event that the POWERBREATHER malfunctions, stop using it

immediately, seek medical attention where necessary and contact us at

[email protected] for service or repair.

/ / Please save these instructions for future reference. Additional copies and

updates are available at www.powerbreather.com.

/ / The use of the POWERBREATHER requires an exact understanding and

observance of this instruction manual.

/ / Prior to the very first use of the POWERBREATHER, practice putting on and

taking off the POWERBREATHER.

ADJUSTING

THIS IS HOW TO SET THE SIZE PROPERLY

1. The lateral headbands enable you to adjust the POWERBREATHER initially to

the approximate size of your head. There are eight holes on each side for this.

The middle hole in each case corresponds to a medium head size (fig. 1).

2. To adjust the size, lift the headbands slightly at the free ends (fig. 2). You can

now push them upward in order to increase the head size. If you pull them

down, then the head size becomes smaller.

3. Always adjust both sides symmetrically.

4. You can fix the setting by clicking the buttons into the holes (fig. 3).

TIP

You can check whether the headband is set

correctly by completely opening the TWIST

LOCK SYSTEM once. To do this, turn the

wheel to the loosest setting. There should

now be a finger width of space between the

back of the head and the headband.