DoorKing 2372-800 Instrucciones de uso

Navegue en línea o descargue pdf Instrucciones de uso para Repetidor DoorKing 2372-800. DoorKing 2372-800 3 páginas. Wireless dual band repeater kit

Imprimir página

WIRELESS DUAL BAND REPEATER KIT

The wireless dual band repeater kit (DBR) extends and expands the wireless communication range between an access control system and wireless

tracker expansion board or "tracker board". It gets installed between the wireless devices that are too far or obstructed from each other to reliably

communicate with each other. It will receive a signal sent to it and repeat that signal to the next wireless device. Multiple DBRs can be used in the

same communication line of a tracker board. The signal range of a DBR is approximately 500 ft direct-line-of-sight with no signal interference.

2361 Wireless

Baseboard

TELEPHONE ENTRY SYSTEM

ABC

DEF

1 1

2 2

3 3

GHI

JKL

MNO

4 4

5 5

6 6

Example:

PQRS

TUV

WXYZ

7 7

8 8

9 9

OPER

0 0

HOLD TO SCAN

OPERATING INSTRUCTIONS

The wireless baseboard

Use "A to Z" Buttons to Locate

Name and Code Number on Display.

Names are In Alphabetical Order.

T o Call, Enter Code Number on

Keypad or Press "Call" Button. If

Line is Busy, Press "#" or "Call" to

Hang Up. Try Again.

MUST be set to:

E nter on Open Display and Tone.

CALL

ID: E CH: 4

LOW PWR switch ON-Up Position,

board is put in a low power operating

mode where both LED signal displays

will turn OFF when not needed.

Base side communicates with the

wireless Baseboard of the 1830

series. The Channel and ID of the

Base side MUST match the Channel

and Net ID of the Baseboard.

DO NOT set Base side the same as

the Remote side.

Installation

1/2" thick wall PVC

IMPORTANT:

conduit recommended

Install the repeater

(not supplied).

so the antenna is in a

Metal conduit may

location that is NOT

interfere with wireless

surrounded by metal

signal.

and is in free air as

high as possible above

the ground. Minimum

15 ft above ground

recommended.

Important Antenna Note:

Antenna range WILL VARY

GREATLY depending on individual

setup: Antenna height above the ground, background signal

interference, physical obstructions (trees, buildings etc.).

Adverse weather (rain) CAN also affect antenna range.

Range testing is HIGHLY recommended

before FINAL installation.

Base Side

LOW PWR

BASE

SW1

BASE

RF RANGE

BASE SIGNAL

BASE

PROGRAM

Black - NEG

12VDC INPUT

2372-011

Red + POS

Rev "C"

Power

or higher

Supply

Circuit

12VDC

Board

Power Transformer

18 GA. Wire 100 ft max

16 GA. Wire 200 ft max

Wire Polarity Matters!

Note: Rev "B" circuit board uses 5VDC.

TELEPHONE ENTRY SYSTEM

ABC

1 1

2 2

GHI

4 4

JKL

5 5

JKL

PQRS

7 7

TUV

8 8

OPER

0 0

OPERATING INSTRUCTIONS

Use "A to Z" Buttons to Locate

Name and Code Number on Display.

Names are In Alphabetical Order.

T o Call, Enter Code Number on

Keypad or Press "Call" Button. If

Line is Busy, Press "#" or "Call" to

Hang Up. Try Again.

E nter on Open Display and Tone.

Baseboard

500 ft

Remote Side

REMOTE

D10

BASE

REMOTE

PAIRED

SW5

REMOTE

PROGRAM

RF RANGE

POWER

RF Range:

Set as shown.

85 MAX setting

Near

Far

Cascading Dual Band Repeaters

Up to 5 Dual Band Repeaters (DBR) can be used in a cascade format to extend

signal distance. The Base Side of 2nd DBR MUST match the Channel and ID of

the Remote Side from the 1st DBR and so on.

Make sure the Channel and ID combinations are

UNIQUE for every DBR in the cascade.

ORANGE

Channels

IDs match

match

YELLOW

and both are

and

Channels

IDs match

in cascade

match

and both are

and

unique

IDs match

in cascade

and both are

unique

in cascade

2nd DBR

1st DBR

DEF

3 3

MNO

6 6

WXYZ

9 9

HOLD TO SCAN

CALL

2358 Wireless

Tracker Board

MUST be set to:

PAIRED

REMOTE

SW4

REMOTE SIGNAL

BASE

REMOTE

RF STRENGTH

Remote side communicates with

the wireless Tracker board. The

Channel and ID of the Remote

RF SYNC

side MUST match the Channel

and Net ID of the Tracker board.

DO NOT set Remote side the

RF LOST

2373-010

PURPLE

Channels

BLUE

match

and

Channels

IDs match

match

GREEN

and both are

and

unique

Channels

IDs match

in cascade

match

and both are

and

unique

in cascade

unique

4th DBR

3rd DBR

Note: DoorKing offers a Wireless Test Range

Kit (P/N 1514-130) to allow easy testing of

the wireless signal between 2 devices at

chosen locations BEFORE installation of the

devices. The self-powered test kit measures

the wireless signal between 2 devices in ANY

chosen locations. Ensuring that a good signal

can be achieved before installation occurs.

DoorKing Part Number

2372-080

Example:

The wireless

tracker board

ID: 2 CH: 9

same as the Base side.

PINK

Channels

match

and

IDs match

and both are

unique

in cascade

5th DBR

Tracker