Astrel Instruments AST8300X Primeros pasos - Página 12

Navegue en línea o descargue pdf Primeros pasos para Cámara digital Astrel Instruments AST8300X. Astrel Instruments AST8300X 19 páginas. Mounting filters
También para Astrel Instruments AST8300X: Manual del usuario paso a paso (4 páginas)

Imprimir página

Astrel Instruments

Tutorial: from power up to the first photo

This tutorial will guide you in the process of making your first photo with your camera. We will

use Windows in Connected mode: most of the steps are the same also with Linux in Connected

mode, while many steps are not needed in Stand Alone mode.

STEP 1: evacuate the camera

• Insert the pump connection tube into the vacuum pump nose

• Screw the pump to the camera's valve

• Pump the air until 25 inHg is reached: if the vacuum level keeps going back to 0, push

the pump nose as much as possible inside the tube and screw the tube as much as

possible inside the valve, until the vacuum is retained: this means that the pump is

correctly connected to the camera

• Open the vacuum valve (the handle should be perpendicular to the camera back)

• Pump the air until a level of 25 inHg vacuum is reached

• Close the valve

• Disconnect the pump and remove the tube

• The camera is now ready for being cooled below freezing temperature and the vacuum

should be retained to an acceptable level for at least 2 days

• You can check the vacuum level connecting the pump to the camera, pumping the air

until a level of 25 inHg vacuum is reached with the vacuum valve closed to remove the

air inside the connecting tube, and then opening the vacuum valve and reading the

vacuum level.

• Note: the level of vacuum of 25 inHg could not be possible to reach on high altitude

locations. In this case pump the air until it can't get any lower

STEP 2: power up the camera

• Plug the WiFi Antenna to the camera and the PC

• If needed plug any USB device and hub to the USB ports

• Plug the power supply

After booting (usually after few secons) the camera emits a weak sound meaning that it is ready

for operation and waiting for VNC connection.

STEP 3: connect to the camera

Getting Started

Remember to close the valve before disconnecting the pump

12/19

AST8300-X

rev A