Astro Tool 613214 Manual de inicio rápido - Página 2
Navegue en línea o descargue pdf Manual de inicio rápido para Herramienta de engarce Astro Tool 613214. Astro Tool 613214 3 páginas. Miniature c-frame tool
Imprimir página
VERIFY THAT THE STATIONARY DIE IS
INSTALLED
CORRECTLY.
INSTALLATION WILL RESULT IN DAMAGE
TO THE TOOL OR THE DIE SET.
3. Cycle the tool to set the dies.
C
O
RIMPING
PERATION
1. The tool must be in the fully open position.
Insert the prepared connector through the tool
opening and place in the cavity. For RF
connector fittings, use the die face as a
locational stop. For shield terminations, locate
the crimp by eye.
2. Squeeze the handles together until the positive
stop is reached. The tool will release and
return to the fully open position.
3. Remove the crimped termination.
D
R
IE
EMOVAL
1. The tool must be in the fully open position.
Using a flat blade screw driver or suitable
device, gently lift on the Die Retaining Plate
and remove the Stationary Die. See Figure #4.
2. With the tool fully closed, slide the Movable
Die out of the tool, as shown in Figure #5.
NOTE: Always remove the Stationary Die first.
CAUTION:
IMPROPER
Figure #4
Figure # 5
T
C
OOL
ALIBRATION
1. Hand pressure of 15-25 lbs. is required to
cycle the tool with a nominal set of dies
installed. Astro has the AT903 spring tester
available for calibration purposes.
2. If calibration of the hand pressure is required,
locate the adjustment screw in the Movable
Die Nest by closing the tool. Using a flat
blade screwdriver, rotate the screw to the right
to decrease the pressure, to the left to increase
the hand pressure. See figure #6.
Adjustment Screw
3. When hand pressure calibration is achieved,
lock the screw in place using an appropriate
NON-PERMANENT sealant.
T
G
OOL
AGING
1. Astro Tool Corp. manufactures flat GO-NO
GO pin assemblies for many of the dies used
by the 613214 crimp tool. Contact the factory
for your specific requirements.
2. With a die set properly installed, cycle the
tool into the fully closed position. Insert the
appropriate GO sized flat pin into the hex
cavity. It shall freely enter the hex cavity. See
figure #7. Remove the GO pin and attempt to
insert the NO-GO pin into the hex cavity. It
should not enter the cavity.
DO NOT CRIMP GAGE,
TOOL DAMAGE WILL RESULT.
2
Figure # 6
GO Pin Inserted
Into Cavity
Figure #7
5-21-15 TI214-94-1