Asus 90MB11H0-M0EAY0 Manual - Página 13
Navegue en línea o descargue pdf Manual para Placa base Asus 90MB11H0-M0EAY0. Asus 90MB11H0-M0EAY0 35 páginas.
Imprimir página
Intel
B365 Serial ATA 6.0Gb/s connectors (7-pin
®
SATA6G_1~6)
These connectors connect to Serial ATA 6.0 Gb/s hard disk
drives via Serial ATA 6.0 Gb/s signal cables.
Clear RTC RAM (2-pin CLRTC)
This header allows you to clear the CMOS RTC RAM data of
the system setup information such as date, time, and system
passwords.
To erase the RTC RAM:
1.
Turn OFF the computer and unplug the power cord.
2.
Use a metal object such as a screwdriver to short the two
pins.
3.
Plug the power cord and turn ON the computer.
4.
Hold down the <Del> key during the boot process and
enter BIOS setup to re-enter data.
If the steps above do not help, remove the onboard battery and short the two pins again
to clear the CMOS RTC RAM data. After clearing the CMOS, reinstall the battery.
System panel connector (20-3 pin F_PANEL)
This connector supports several chassis-mounted
functions.
•
System power LED (4-pin +PWR_LED-)
This 4-pin connector is for the system power LED.
Connect the chassis power LED cable to this
connector. The system power LED lights up when
you turn on the system power, and blinks when
the system is in sleep mode.
•
Hard disk drive activity LED (2-pin +HDD_LED-)
This 2-pin connector is for the HDD Activity LED. Connect the HDD Activity
LED cable to this connector. The HDD LED lights up or flashes when data is
read from or written to the HDD.
•
System warning speaker (4-pin SPEAKER)
This 4-pin connector is for the chassis-mounted system warning speaker.
The speaker allows you to hear system beeps and warnings.
•
ATX power button/soft-off button (2-pin PWR_SW)
This connector is for the system power button. Pressing the power button
turns the system on or puts the system in sleep or soft-off mode depending
on the operating system settings. Pressing the power switch for more than
four seconds while the system is ON turns the system OFF.
1-5
SATA6G
GND
RSATA_TXP
RSATA_TXN
GND
RSATA_RXN
RSATA_RXP
GND
CLRTC
PIN 1
PANEL
+PWR_LED-
SPEAKER
PWR_SW
CHASSIS
PIN 1
+HDD_LED-
RESET
+PWR_LED-
* Requires an ATX power supply
ASUS PRIME B365-PLUS