Asus YNRC-BR Manual del usuario - Página 17

Navegue en línea o descargue pdf Manual del usuario para Placa base Asus YNRC-BR. Asus YNRC-BR 22 páginas.

6.2

Internal connectors

This section describes and illustrates the internal connectors on the

motherboard.

IDE connector (40-1 pin IDE1)

This connector is for an Ultra DMA 100/66 signal cable. The Ultra DMA

100/66 signal cable has three connectors: a blue connector for the

primary IDE connector on the motherboard, a black connector for an

Ultra DMA 100/66 IDE slave device (optical drive/hard disk drive), and

a gray connector for an Ultra DMA 100/66 IDE master device (hard disk

drive). If you install two hard disk drives, you must conﬁgure the second

drive as a slave device by setting its jumper accordingly. Refer to the

hard disk documentation for the jumper settings.

•

Pin 20 on the IDE connector is removed to match the covered hole on

the Ultra DMA cable connector. This prevents incorrect insertion when

you connect the IDE cable.

•

Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.

YNRC-BR IDE connector

ASUS P5RC-BR

NOTE: Orient the red markings

(usually zigzag) on the IDE

ribbon cable to PIN 1.

PIN 1