AmpliVox TITAN WIRELESS SW800-96 Manual del usuario - Página 9

Navegue en línea o descargue pdf Manual del usuario para Sistema de altavoces AmpliVox TITAN WIRELESS SW800-96. AmpliVox TITAN WIRELESS SW800-96 12 páginas. Titan wireless battery powered pa system
También para AmpliVox TITAN WIRELESS SW800-96: Manual del usuario (12 páginas)

WIRELESS DUAL RECEIVER (OPTIONALEQUIPMENT)
This receiver will allow you to use two wireless microphones, each with its own volume control. Each receiver has 96
different selectable frequencies.
FEATURES
Power / Volume Control (A1)
Power / Volume Control (B1)
Channel Display with Signal Strength Meter (A2)
96 Frequencies 514 - 544 MHz
Channel Display with Signal Strength Meter (B2)
96 Frequencies 514 - 544 MHz
Set Button (C)
Select Buttons - Manual Channel Selection (D1 / D2) Up / Down
SETUP
Each receiver has its own POWER / VOLUME Control (A1 / B1). First start with A1. Turn Power On. Channel Dis-
play (A2) will show "ON" and show last frequency channel used. To select a clear channel, press and hold the UP
SELECT (D1) button until SCAN shows in the display. Receiver will scan for the next clear channel and stop. Turn
on the Wireless Transmitter (Bodypack or Microphone) On these, press and hold the SET button until its channel
display starts to FLASH. Press the UP/DOWN Select buttons to choose the same frequency as the receiver. Press
SET button to lock channel.
For the second receiver (B1), Turn Power On. Channel Display (B2) will show "ON" and show last frequency
channel used. To select a clear channel, press and hold the DOWN SELECT (D2) button until SCAN shows in the
display. Receiver will scan for the next clear channel and stop.
TRANSMITTER SETUP: Turn on the Wireless Transmitter (Bodypack or Microphone). Press and hold the SET
button. Display will FLASH. Press the UP/DOWN Select buttons to choose the same frequency as the receiver.
NOTE: Complete the frequency setup in one receiver first and then set up the second receiver.
BE SURE TO SELECT A DIFFERENT FREQUENCY FOR EACH RECEIVER with MATCHING TRANSMITTER
When receiver is receiving a signal, the SIGNAL STRENGTH METER (above the letter A or B in the display) will
light. The number of bars that are lite will show how strong signal is. If weak, you may want to select another fre-
quency.
To manually select a frequency channel on A1 RECEVIER, press and hold the SET BUTTON until the A2 channel
display starts to FLASH. Use the UP or DOWN ARROW BUTTONS (D1 / D2) to select new channel. Press SET
button to lock channel. If you need to change the B1 RECEIVER just press the SET button again and the B2 dis-
play will start to FLASH. Use the (D1/D2) buttons to select new channel. Press set button to lock channel.
Channel number must match channel number on wireless transmitter (Bodypack or Microphone)
A1
9
A2
B2
B1
C
D1
D2