AMSOIL BMK-15Ea Instrucciones de instalación y mantenimiento - Página 6

Navegue en línea o descargue pdf Instrucciones de instalación y mantenimiento para Sistemas de filtración de agua AMSOIL BMK-15Ea. AMSOIL BMK-15Ea 6 páginas. Dual remote filtration system

Imprimir página
Diagram G
1. Provide for length change
WRONG
RIGHT
In straight hose installations allow enough slack in
the hose line to provide for changes in length that will
occur when pressure is applied. This change in length
can be from +2% to -4%.
4. Avoid mechanical strains
WRONG
Use elbows and adapters in the installation to relieve
strain on the assembly, and to provide easier and
neater installations that are accessible for inspection and
maintenance.
7. Secure for protection
WRONG
Install hose runs to avoid rubbing or abrasion. Use clamps to support long runs
of hose or to keep hose away from moving parts. It is important that the clamps
do not allow the hose to move. This movement will cause abrasion and pre-
mature hose failure.
Diagram H
INSTALLING AN OIL SAMPLING PETCOCK
ON THE SPIN-ON BY-PASS:
Getting a clean and uncontaminated oil
sample is easy and simple when an oil
sampling pet-cock is installed into the Spin-
On By-Pass Oil Filter system. This can be
easily done by ordering a BK-13.
Installs in place of the BP-191 Allen Head
Plug.
To order By-Pass Oil Filter Parts or oil sample kits, consult your AMSOIL Dealer or the AMSOIL Product Price List for your country.
AMSOIL INC., AMSOIL Bldg., Superior, WI (715) 392-7101
2. Avoid twisting and orient properly
WRONG
Do not twist hose during installation. This can be deter-
mined by the printed layline on the hose. Pressure
applied to a twisted hose can cause hose failure or
loosening of connections.
5. Use proper bend radius
RIGHT
WRONG
Keep the bend radius of the hose as large as possible
to avoid collapsing of the hose and restriction of flow.
Follow catalog specs on minimum bend radii.
RIGHT
Most of these items are available from your AMSOIL Product Center.
RIGHT
RIGHT
8. Avoid Improper Hose Movement
WRONG
Make sure relative motion of the machine components produces bending rather than twist-
ing of the hose. Hose should be routed so that the flex is in the same plane as the equipment
movement.
Oil Analysis:
1. If installing By-Pass Oil Filter with AMSOIL Air Filter and 100% Synthetic Engine Oil in a
pleasure vehicle, we recommend the TRIGARD Oil Analysis Program:
a. TRIGARD 1 (Stock No. ATG-01) is the starter program. It contains material for reg-
istration and 2 prepaid analysis to check oil's condition.
b. TRIGARD 2 (ATG-02) is for all subsequent oil samples. Each ATG-02 also contains
materials for 2 prepaid oil analysis.
2. For other oil analysis order G-1318 Oil Analysis Sampling Kits (in U.S., Canada). Consult
AMSOIL Technical Service for details.
3. Protect from hazardous environment
WRONG
RIGHT
Keep hose away from hot parts. High ambient temper-
atures will shorten hose life. If you can not route it
away from the heat source, insulate it.
6. Use proper bend radius (cont.)
3.00
RADIUS
B
6.00
DIAMETER
Maximum bend radius is measured on the inside bend
of the hose. To determine minimum bend, divide the
total distance between ends (B length) by 2. For exam-
ple B = 6, minimum bend radius = 3.
RIGHT
BP-174 8/06