Bosch WTA74202ID Manual de instrucciones de instalación y funcionamiento - Página 34
Navegue en línea o descargue pdf Manual de instrucciones de instalación y funcionamiento para Secadora Bosch WTA74202ID. Bosch WTA74202ID 40 páginas.
Imprimir página
Faults and what to do about them
en
Faults
Drying time too long?
Condensation in the
exhaust air duct.
Displayed drying time
changes during drying
process.
Humidity in the room
increases.
One or more indicator
lights are flashing.
Power cut.
* depending on the model
If you cannot rectify the fault yourself by turning the dryer off and on, please
Note:
contact our after-sales service.
34
Cause/remedy
The fluff filter may be dirty and cause a longer drying time. Clean the fluff fil-
■
ter.
Unsuitable programme selected?
■
Dryer installed too closely to other objects? Provide adequate air circulation.
■
If the ambient temperature is higher than 35 °C, this may extend the drying
■
time.
Insufficient air circulation in the room may increase the drying time. Ventilate
■
the room.
Mains failure? Restart the dryer.
■
Exhaust air duct too long? Check the maximum exhaust air duct lenght. Futher
information ~ Page 15.
Not a fault. The moisture sensors detect the remaining moisture in load and cor-
rect the programme lenght (except timed programmes).
Not a fault. Make sure the room is sufficiently ventilated.
■
Exhaust air duct installed/the exhaust air routes directly into the open air?
■
~ Page 15
Clean the fluff filter ~ Page 29.
■
Check the installation condition ~ Page 14.
■
Exhaust air duct blocked or bent? Clean the exhaust air duct ~ Page 32.
■
Switch off, allow to cool, switch back on, and restart the programme.
■
The drying program is interrupted. Remove the laundry and spread it out, or
restart the program.
Note:
Be careful as the door , the drum and the laundry may be hot.