Dreamline ENIGMA-Z SHDR-62487610 Series Manual de instrucciones de instalación - Página 16

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Productos de fontanería Dreamline ENIGMA-Z SHDR-62487610 Series. Dreamline ENIGMA-Z SHDR-62487610 Series 20 páginas. Shower door & tub door

Imprimir página

15.

Use the

Roller Installation tool

assemblies (#04) to the Glass door (#05)

Suspend the door by hanging the Roller assemblies (#04) onto

the Upper guide rail (#03) and sliding the bottom edge of the

Glass door (#05) into the groove of the Guide block (#12). Be

careful not to damage the bottom edge of the door glass.

Adjust the door glass if necessary using the set screws on the

rollers as shown below in Fig 19.

Roller Guards must be adjusted to within 1/16" of the Guide Rail

(#03) to prevent the door from being removed. Tighten all set

screws.

TIP: Use a 1/4" shim beneath the

door glass when you adjust the

level of the installe door glass so

the bottom of the glass does not

make contact with the guide block.

NOTE: Adjust the height of the door if necessary by loosening the set screws on either side of the

wheel. Move the door glass to the proper height and re-tighten the set screws. Be sure to support

the door glass during the process.

NOTE: During adjustment you must support the door glass so that it does not make contact with

the guide block. Leave approximately 1/8" of space between the bottom of the glass and the guide

block, (or 1/4" clearance between the bottom of the glass and the threshold.) Use a 1/4" shim on

the threshold to prevent adjusting the door glass too low.

ENIGMA-Z manual Ver 1 Rev 4 10/2016

to install the

After hanging the door, the

See Fig. 18 and Fig 19 for details

roller guard

roller height

adjustment range

two Roller

(Fig

18.1).

Roller Installation

Tool

Fig. 19

Fig. 18