Electrolux E30WV60PPS Manual de instalación, uso y mantenimiento - Página 11

Navegue en línea o descargue pdf Manual de instalación, uso y mantenimiento para Campana de ventilación Electrolux E30WV60PPS. Electrolux E30WV60PPS 12 páginas. 30"(76.2 cm) and 36"(91.4 cm) range hood
También para Electrolux E30WV60PPS: Manual de instalación, uso y mantenimiento (12 páginas)

Maintenance
ATTENTION! Before performing any maintenance
operation, isolate the hood from the electrical supply
by switching off at the connector and removing the
connector fuse.
Or if the appliance has been connected through a plug
and socket, then the plug must be removed from the
socket.
Cleaning
Do not spray cleaners directly to the control while
cleaning the Hood.The cooker hood should be
cleaned regularly (at least with the same frequency
with which you carry out maintenance of the fat filters)
internally and externally. Clean using the cloth damp-
ened with neutral liquid detergent. Do not use abrasive
products. DO NOT USE ALCOHOL!
WARNING:
Failure to carry out the basic cleaning recommenda-
tions of the cooker hood and replacement of the filters
may cause fire risks.
Therefore, we recommend oserving these instructions.
The manufacturer declines all responsibility for any
damage to the motor or any fire damage linked to
inappropriate maintenance or failure to observe the
above safety recommendations.
Grease Filter
To Remove Metal Grease Filters:
Use 2 hands to remove the metal grease filters.
Grasp filter handles, push toward the rear of
the range hood and pull down on the front handle
to remove.
To Reinstall Metal Grease Filters:
Grasp filter handles and place rear of filter into
rear track.
Push down on the rear handle and set the front of
the grease filter into the front track to secure.
Repeat for each filter.
Wash metal grease filters as needed in a
dishwasher or hand wash in a hot detergent
solution to clean.
Replacing the light bulb
CAUTION
Before replacing the lamps, switch power off at
service panel and lock service panel disconnecting
means to prevent power from being switched on ac-
cidentally.
NOTE: Turn off the lights and fan. Allow the lights to
cool before handling. If new lights do not operate be
sure lights are inserted correctly before calling service.
1
Replace Lights
Remove the damaged light (twist counter clockwise)
and replace with a new 120 Volt, 50 Watt (maximum)
50° halogen light made for a GU10 base, suitable for
use in open luminarie.
Maintenance
2
11