Electrolux EFC 6441 Manual del usuario - Página 9
Navegue en línea o descargue pdf Manual del usuario para Campana de ventilación Electrolux EFC 6441. Electrolux EFC 6441 24 páginas. Electrolux cooker hood
También para Electrolux EFC 6441: Instrucciones de uso e instalación (15 páginas), Instrucciones de uso e instalación (16 páginas)
Filter checking device
Filter checking device
Filter checking device
Filter checking device
Filter checking device
The cooker hood is fitted with a
device which indicates when the filter
must be cleaned or replaced.
Usually the device, which signals
when the carbon filter needs
maintenance work, is deactivated
To activate it, proceed as follows:
Switch off the cooker hood.
Press the knob and rotate it by 90° in
a clockwise direction.
The L2
L2 LED begins to flash in green
L2
L2
L2
and after approximately 2 seconds
L2
L2
the L2
L2
L2 LED will also begin to flash in
orange, to indicate that the device,
which indicates when it is necessary
to perform carbon filter maintenance,
activated
activated
has been activated
activated
activated.
L2 LED - grease filter indicator
L2 LED - gr
L2 LED - gr
ease filter indicator
ease filter indicator
ease filter indicator
L2 LED - gr
L2 LED - gr
ease filter indicator
The LED lights up in green when the
grease filter needs to be cleaned; this
happens approximately every 40
hours of operation.
Every time the cooker hood is used,
check whether the L2
L2 LED - carbon filter indicator
L2 LED - carbon filter indicator
L2 LED - carbon filter indicator
L2 LED - carbon filter indicator
L2 LED - carbon filter indicator
The LED lights up in orange when
the carbon filter needs to be cleaned/
replaced; this happens approximately
every 160 hours of operation.
Every time the cooker hood is used,
check whether the L2
deactivated
deactivated
deactivated.
deactivated
L2
L2
L2
L2 LED is lit.
L2
L2
L2 LED is lit.
L2
electrolux
electrolux control panel
electrolux
electrolux
electrolux
Resetting the filter saturation war
Resetting the filter saturation war
Resetting the filter saturation warning
Resetting the filter saturation war
Resetting the filter saturation war
After cleaning or replacing the filters,
switch on the cooker hood at any
suction speed (power), then press
and hold the knob for more than 3
seconds, until you hear a beep
indicating that the reset procedure
has been performed successfully.
The L2
L2
L2 LED and the cooker hood
L2
L2
both switch off.
In some situations (for example,
when the L2
L2
L2
L2 LED is indicating that
L2
the grease filters and the carbon filter
are saturated), the procedure
described above must be repeated.
9 9 9 9 9
ning
ning
ning
ning
GB